Recent content by pointer434

Can anyone tell me if the Cisco 2621, version 12.2(17a)will support the MLPPP protocol? Thanks gary

Thanks for all the help with this one but I figured out what the problem was. Actually it had nothing to do with the PIX config but rather the gateway setting on the PC (and all the other PC's). See, we use a proxy server that runs an internet content filter on it and I usually set the client...

Thanks for the reply!! I really do appreciate it. But i really want to understand what is going on here. My machine can telnet out on 22 or 23. The machine that i need to enable cannot but for the life of me, i cant see in the confing anything that is permiting my machine access. Also, the...

Hello all, I have one PC that is vendor supplied that needs to be able to telnet out to the vendor to initiate updates and so on. I have successfully configured telnet to be permitted from the IP of the PC to the PIX but i cant seem to get out and past the PIX with telnet. What i mean by this...

Thanks, this is what is was thinking of but did not know what it was called. Thanks again.

We have a Cisco 2621 Router with 1 WIC attached to a T1. We are in the process of adding a second T1 and will load share the two for 3 meg of WAN bandwidth. I am planning on using the second slot for a second T1 WIC on the router. This will use up the three interfaces on the router. There also...

Sure bell1996, There are already routes in that look like this, actually, there are 4 for each device. Data and status ports, (2 port numbers per device) UDP and TCP on each one ie.. tcp 6661 udp 6661 tcp 6662 udp 6662 Below is an actual static route from the config... static...

Ooops, i posted this in the Router section by mistake so here goes... I have a PIX 501 and am tring to add a static route for a PC anywhere connection so that a remote tech can access a server on my LAN> The actuall access lists went in with no problem but i ran aground when tring to put in a...

I have a PIX 501 and am tring to add a static route for a PC anywhere connection so that a remote tech can access a server on my LAN> The actuall access lists went in with no problem but i ran aground when tring to put in a static route to compliment the ACL. The local ip option is the problem...

Hsh2Hsh Thanks for the info. I will save this for future use. Thanks agian, Pointer

JimmyZZ You are da man!!!!!!!!!!!! Setting the baud rate to 1200 did the trick. Thanks a bunch!!!!!! I love you guys Pointer

During an ill fated password recovery on a Cisco 1601 Router I put in a wrong statement for a register setting. I assume that this is my problem but as of now, the router will not reboot and all I see is a blank screen in HyperTerminal. The recovery instructions call for putting in the...

I am sorry if i mislead you there. Yes, all the normal icons show in control panel; just not one for Automatic Updates. I'm really sorry that i sent you barking up that tree. me bad Pointer

I went to 2 of the 98 machines and from the run box i enterd control wuaucpl.cpl and the run box disapears. Same thing from the dos prompt. It just returns to the C:\ like it is a good command but it never opens up a file. On my administrator 2000 workstatin (not one of the problem PC's) i...

Nothing shows up in Control panel. ????? Nothing is in Add/remove programs. This is killing me. Pointer