Recent content by pluff

Sorry , not been on line much. Just get into config as you described and then set everything to manual. the last (or almost last) option it TFTP IP. This will work on any switch that complies with 802.1af or use a powerpack.

- Install TFTP Server - Config the data directory (program specific but most have a default) - Put firmware into directory above - run or start TFTP Server - Manually program phone TFTP option to be address of server above (make sure the phone and pc are on the same subnet) - reboot phone -...

Loadware <=/=> Firmware are two different things. To load phone firmware just mannually configure the phone and point the TFTP option to your PC and be running a TFTP server like "BulletProof TFTP" or any other, there are lots out there. The phone will connect and install the file you have...

Hi all, I am wanting to get an understanding of the requirements to install CS1000 systems (AACC, AVP, CP, etc.)and how this would be affected by a secure network enviroment. Here is a scenario; Installer is supplied company laptop. Security policies will be excessive so only approved apps...

No, Config wiz has no affect BUT I think I am on to it. My guess is that the lanuage file is corrupted. I am not sure of the orriginal lanuage that was installed but I installed two lanuages (english US & AUS) on a recomendation from Avaya unrelated to this job. After swapping a users lanuage I...

All the latest peps were installed prior to running the upgrade wizard. I generally build on a new drive off site then install and run the setup wiz then the config wiz from the client. Then the latest upgrade wiz to put in the database. I reboot, and run the config wiz to update the TNs to...

Hi All, I have a problem where after upgrading from CP4 to CP5 users can not access their mailbox after the password is reset. If they enter their password they get a recording stating that their call can not be processed at this time and then they disconnect. Strangely I can access the mailbox...

From what I understand thia is correct but there are a lot of options and I can't even provision just the S1, retry, etc. that are acceprtd by the 'A' string. Given that it works on the 11xx phones I am at a loss. And then having phones "remember" their IP settings???? This shouldnt be a big...

Good call, I will do that. Just part of the joy of working on these systems :)

Looks that way but the documents clearly say that the provisioning block is supported via DHCP. Both in IP Phone fundementals and Unistim 3.3 bulitin?????

Can someone please clarify how the provisioning zones are determined? Assume we have two sites, A & B. A single provisioning server is located at site A and call centre phones connected directly to site A are located at site B. How can I use the zone files SiteA.prv and SiteB.prv? As far as I...

Apparently so, I am doing this for a customer now but the first step is to upgrade all software to the latest releases including the PABX and you need SRS

Hi All, I am installing a provisioning server and during testing pushed the latest firmwate to a couple of phones (1140 Unistim 5.5). Because of multiple sites and change control I can't deploy the current firmware yet but I can't roll back to the previous firmware either as the certificate has...

Hi All, I am wondering if someone can explain how to auto provision i2002 / i2004 phase 2 handsets with dhcp? I configured opt 224 with the B-String and provide S1= etc. info and option 227 with the B-string and the prov= (just to make it neat). This all works for 1100 series phones, I get the...

Hi, I am not much of a programmer - I tend to just bolt bits of code together to get what I want. My problem is that I need to make a script that will time expire and not let people do silly things like set the clock back. I have a script that can do this (compiled version only), it uses the...