Recent content by pjolly

What voice mail products (Lucent/Avaya only, please) are compatable with the Partner Plus system? I'm pretty certain that big mail and vs work, but how about a messaging card (new or old version)? Thanks.

I'm not familiar witht the designation "H-103", so the following may not apply. This is the programming for a Partner ACS (& earlier versions, I believe, such as Partner Plus): At extension 10, press the feature button, then dial 00; Press the left intercom button twice; Press the pound key...

799 is absolute...you cannot remove any extensions. And yes, there is a limit of 10 extensions per group for 793-798. It may be necessary to assign just a few phones per area...if you just have one per room, and that phone is in use, the room will not hear the announcement. By the way, you...

One work around is to make mailbox 3967 assigned to DN 3902, but that's not a great solution. As I understand it, you changed the dn in programming from 3902 to 3967. If so, check (feature *0) the set again...sometimes programs changes are not instantaneous, and it may be ok now. If not...

In programming, show a.config and use next to system data. Show sys data and next to individual DN (actually, it may be the first option under sys data). Show individual DN. If prompted for old DN, enter 3902, then enter 3697 for new DN. (You may need to use next to get to change dn...not...

Sorry...my bad for assuming newer software. This may help: TO ASSIGN DID TO A SET (EARLY SYSTEMS) 1. Enter into programming by pressing Feature **266344 266344 2. The display reads “A. Configuration”. Press SHOW. 3. The display reads “1. Trk/line data”. Press SHOW. 4. The display reads...

And, by using outcalling, if your system has it, you can set the mailbox to page a tech at night. TouchToneTommy rocks!!!

Sounds like you got it all except assigning the line to the set. Assigning a line to a set: You can assign a line to a set as “Ring Only”, “Ring & Appear” or “Appear Only”. If assigned with appearance, the line will appear on eight-button sets starting on the top button, and on ten- or...

First, add the extensions you want to ring to calling group (recommend you use calling group 2, since 1 is often programmed for group paging) as follows: - At ext. 10 or 11, press feature zero zero - press left intercom twice - press pound (#) 502 - enter 2, enter extension to add, enter 1...

enter 9997 pound for the extension, enter the serial number followed by pound for the password. It should say "goodbye". If this is a module, look for a tiny hole that says "reset". Within 5 minutes of "goodbye", press an opened paperclip into the hole and hold down the tiny button for a...

ASA or automatic system answer can be programmed to answer all calls after a specified # of rings, give a brief greeting, and then: a. place call on hold at extension 10 b. ring all extensions programmed with that line, or c. hang up DXD or direct extension dial answers after specified # rings...

If you would like a "cheat sheet" for programming the CCR, please send me an email at pjolly@yahoo.com and I'll reply with a word attachment.

If you're using a CCR tree, you can define a path (let's say 8) as an info path. When the record screen comes on, press record, then press OK immediately. The next option after you approve the recording is to define where the call routes after playing the info message. Select HOME. When you...

The voice mail system in question is not messaging, but Merlin Mail (the 008 card). Would appreciate any info.

I believe that unless you have Centrex, you cannot forward lines off-site with a Partner system. If you do have Centrex, you may be able to program a selector code in your auto attendant to perform centrex transfer. I know that Partner VS allows this, but am not sure about big mail. Go into...