Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by pingerang
-
PIX 515e Failover Management
Hi List, I have a 515e failover pair which I have been tasked to manage. I'm wondering how I go about modifying the configuration. Do I only have to modify one of the firewalls, or both separately?- pingerang
- Thread
- Replies: 2
- Forum: Security, hacker detection & forensics
-
VRRP Failover
Hi List, I am designing a VRRP solution for a WAN Gateway at multiple branch office locations. Each location has a router which will provide gateway access to the WAN for 2 different interfaces. However we would also like to fail over the WAN, as it's IP address must be accessible from all... -
Re-Routing Traffic
Its a bit like this: All interface IP addresses are private, the default gateway points across a WAN to another lot of private ranges, but we have contractors I who have static routes for which i point to the inside of the firewall for their response traffic. However there are two ways into the... -
Re-Routing Traffic
Hi all, I have a routing table set up on a router with multiple interfaces and using static routing. I have one interface which goes out to the internet via a firewall. We have a default route pointing out an internal interface that does not access the internet. What I am trying to achieve is... -
VRRP Question
OK that helps, Now does anyone know if an SVI interface on an HWIC can be used as a VRRP interface or do we have to use a router port? Thanks. ping. -
VRRP Question
Hi List, I have a question on VRRP. HSRP is also an option. We are using static routing on our gateway routers. I'm wondering if we implement VRRP, then how will configuration and router management be done? When I add a new route, or reconfigure a port, which is quite common, then will this... -
Preventing BPDUs from traversing Trunk
Hi List, We have a 2800 router with SVI interfaces. We are using two of the HWIC SVI interfaces to access an MPLS network in trunk mode. The trouble is that BPUS are traversing from one VLAN+fa0/0/0 trunk to another VLAN+fa0/0/0 trunk. We have discovered that BPDUs are crossing from one part... -
VIC-2FXS not recognised by 2811
I'm not a big fan of the HWIC 2811's we had a second 9 port HWIC put in and discovered that in order for it to work we had to patch a cable from the first HWIC into the same router to the second HWIC! -
Verifying Queueing
Hi List, I have moved a cable on a 2811 to a router interface form an HWIC in order to enable some QoS. The has improved considerably since I have applied the following: policy map TC class class-default shape average 1000000 fair-queue interface fa0/0 service-policy output TC I can see... -
QoS on Cisco 2811 HWIC interface
I'll give it a try. What I have currently is: policy-map TEST class class-default shape average 1000000 fair-queue interface vlan 101 service-policy output TEST this works fine on the 2800 series L3 interface but not on a L2 SVI assigned to a VLAN with IP address. It cannot be assigned as... -
QoS on Cisco 2811 HWIC interface
yes, can apply outbound with Police to drop on action-exceed, but does not work with Shape 1000000, fair-queue, this policy when applied outbound only works when applied on a L3 router interface and not an HWIC SVI. So it is pointless really as it is already being Policed to drop on exceed at... -
QoS on Cisco 2811 HWIC interface
Hi, I've tried this, as this was the first test, and it applies and works on a router interface, but not a VLAN interface which an HWIC L2 interface must be assigned in order to apply an IP address. -
QoS on Cisco 2811 HWIC interface
Hi List, I've got a Cisco 2811 with an HWIC connected to a new MPLS WAN. However we are getting sporadic traffic patterns and large traffic drops at the service provider due to the MPLS Policing traffic over 1Mbit to drop. I need to apply some sort of QoS in order to get consistent traffic... -
Static Routing Table
It's a hub and spoke, with this router & its routing table being the central hub. -
Static Routing Table
No, it's a different router in a different part of the country, but it is in the same cloud.
