Recent content by PHONMAN

Here it is: CICS6.1 CP150; When business closes and uses time table greetings and ccr plays correctly. Now bad weather is coming and customer wants to close for day tomorrow... F 982 business closed OK, but only closed greeting plays not the tree that normally follows the night greeting. Whats...

I have a new customer that had nite ring thru the over head page when in nite service. Something happened "event" unclear but they (cust)replaced pwr supply and paging came back but not nite ring(Older 8x24DS W/DR5 with startalk mini, Valcom 24v speakers and pwr supply) the paging works fine but...

Thanks phoneguy I'll check, some are set for message notification but you never can tell if the users have changed something. Phonmancps@comcast.net SMalcolm CustomPrewire in K.C.

60" to the middle of the box/plaster ring that you mount the jack to is what I've always used. Phonmancps@comcast.net SMalcolm CustomPrewire in K.C.

CP150 on ICS 6.0 this setup has been in service for about 2 months and about 2 weeks ago it started answering incoming calls with this message "cannot continue with this session, goodbye" and then disconnects. If I or the customer reset the CP by powering down for about 30 sec. When it comes...

CP150 on ICS 6.0 this setup has been in service for about 2 months and about 2 weeks ago it started answering incoming calls with this message "cannot continue with this session, goodbye" and then disconnects. If I or the customer reset the CP by powering down for about 30 sec. When it comes...

You will need a 616DS cabinet as well as DS software. Phonmancps@comcast.net SMalcolm CustomPrewire in K.C.

Thanks Phonmancps@comcast.net SMalcolm CustomPrewire in K.C.

Customer wants many phones to ring at the same time on incoming calls after it rings say...4 times at ext. 201. I'm looking for some sort of delayed ringing, but all I see is "appear and ring" or programing for "answer DN" or "foward no answer" I must be brain dead...

Thanks guys......I didn't assign the night button when I put in a new proc. and using the restore on the backup card it didn't take. that appears to have cured my problem. Phonmancps@comcast.net SMalcolm CustomPrewire in K.C.

Customer has ACS 5.0, in 5 slot carrier as follows, 206e,400, ACS proc, partner mail vs R4 remaining slot empty. set to answer night only, but answers after 5-6 rings saying "Your call is being transfered" and rings at ext 10. Hunt schedule#507 is night only. The question is can I make...

Thanks for the reply, I'll move the answer machine to his desk. Phonmancps@comcast.net SMalcolm CustomPrewire in K.C.

I'M HOOKING UP AN ANSWERING MACHINE TO AN ATA ON A CUSTOMERS CICS WHILE HIS FLASH IS IN FOR REPAIR. I THOUGHT IT WOULD WORK REALLY GOOD. BUT IF WHEN I DIAL THE ATA EXT. THE MACHINE ANSWERS BUT THE PHONE DOESN'T SEEM TO DELIVER A LONG ENOUGH TONES TO ACCESS (TRIP THE MACHINE) TO GET MESSAGES, IS...

Thanks again, I'll double check all my programing. Phonman@comcast.net SMalcolm CustomPrewire in K.C.

Thanks Brian, I had the ACS proc. go down last week. Replaced the proc.and I thought I got all the programing done but it's doing some funny things. Now when a call comes in it answers and says "your call is being transfered". When I try to go in to admin 0# @ ext. 10 it says the same...