Recent content by Phoneman2

Just tell them it's a system setting, They should have more important things to worry about then what there phone display shows. Wisdom is Knowledge that is Shared Thanks All Phoneman2

From the trunk page Supplementary Service Protocol: a From the DS1 page Protocol Version: b Wisdom is Knowledge that is Shared Thanks All Phoneman2

I have , Jeff [3:39 PM]: makes no diff , Jeff [3:39 PM]: most of our local service T1s have "speech" Wisdom is Knowledge that is Shared Thanks All Phoneman2

Our IN office put in 4 new Pri_ISDN local T1s last night. D channels are up and so are the B channel,,,But when you call out to a cell phone there is no talk path. Can't hear them they can't hear you. But caller ID shoes up. TRUNK GROUP Group Number: 104...

I am removing 2 G650 from a rack of 5. Units B and E are empty and we had hopes of removing them. Leaving us with A,C,D. I have been now told we can not remove B, due to the TDM cable and the termimator on the end of E. I would perfer not to move everything to B from D. Leaving us with A,B,C...

Your correct, almost forgot. The recording will still be there correct? Wisdom is Knowledge that is Shared Thanks All Phoneman2

If I move a val board from 01D03 to 01B04 will I lose all the wav files. I don't think so and will also back up to lap top in case. Wisdom is Knowledge that is Shared Thanks All Phoneman2

OMG is there no way to lower the volume on this thing. When it rings through the pc it is so load. Wisdom is Knowledge that is Shared Thanks All Phoneman2

Ok CBT is installing the New C-Lan card and I will be added the Port Network. I just need to find out HOW!!! We are adding a new call account system from Telesoft out of Phx....Funny I use to work there. Wisdom is Knowledge that is Shared Thanks All Phoneman2

You don't work in a place that has a lot stuff flying around do you, like a dead animal smelter or something like that?? and no I did not smell my phone. Wisdom is Knowledge that is Shared Thanks All Phoneman2

We closed two location over the summer an now have a SP-REG-M alarm. I still show the two LSP's in the li SUR report. I need to remove then. Wisdom is Knowledge that is Shared Thanks All Phoneman2

Just found my answer. If one of the hunt groups has multi-call-handle turned on, you can not get logged into two different splits. ON-ON of OFF-OFF Wisdom is Knowledge that is Shared Thanks All Phoneman2

Our agents were able to login to more then one split at a time. (I know start using EAS) We moved up to CM4 about 9 months ago and this just came up today. The phones are setup with 2 auto-ins and acw and aux. They can log into each split fine ,but not both at the same time. Wisdom is Knowledge...

We are at HW 01 and FW021. The card is the only one at HW 01, the others cards are HW 02 or 03 Wisdom is Knowledge that is Shared Thanks All Phoneman2

I have had VAL Boards lock up and block calls. Meaning the board needs to be Busy Reset Released to get it working again. Now I have to do a RCA report. (root cause) for the management team. Has anyone found the reason yet? Wisdom is Knowledge that is Shared Thanks All Phoneman2