Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by phoneguy427

  1. phoneguy427

    Networked IP office ringing over amplifier

    The customer ordered a sip paging adapter, configured it, and now I get to install it next week with an amp a speakers. Hopefully it works well.
  2. phoneguy427

    Networked IP office ringing over amplifier

    Thank you for the information, I will look into these options, and update when it gets finalized.
  3. phoneguy427

    Networked IP office ringing over amplifier

    I have a customer that has a remote location with 2 phones connected through the network to the home office a couple of km's away. They want to set up an amp with a couple of horns for incoming call ringing only. I never had that scenario asked before. Any ideas would be greatly appreciated.
  4. phoneguy427

    Call Pilot 150 External Transfer Not Working

    Do you have supervision set on all the lines? also can you answer a call and manually transfer the call externally using f71? Under terminals and sets/restrictions there is allow link, I'm not sure if that applies to call pilot extensions, it's been a long time.
  5. phoneguy427

    Intercom button disappeared, replaced with Feature 987

    Check in terminals and sets to see how many intercom buttons are assigned to that extension, prbably set to 0 www.linkedin.com/in/Phoneguy427
  6. phoneguy427

    Nortel 3x8 with CP100, used to work, no longer does

    It sounds like the 3x8 has a corrupt bit in it, I would do a startup and reprogram, it's a 3x8, should take about ten minutes to reprogram and hopefully it will then connect to the cp. I think I had a cics do this to me once many moons ago. www.linkedin.com/in/Phoneguy427
  7. phoneguy427

    MICS GATC going dead

    You might want to check the grounds on all the modems compared to the ksu ground. A floating ground might cause you some grief. www.linkedin.com/in/Phoneguy427
  8. phoneguy427

    Music on Hold stopped working after storm and trunk card replacement

    It's a longshot but you could try to reverse polarity on the audio input pair, it has worked for me once or twice. www.linkedin.com/in/Phoneguy427
  9. phoneguy427

    Greetings! I have setup "Outboun

    Found this, you must be set as call pilot interface. www.linkedin.com/in/Phoneguy427https://files.engineering.com/getfile.aspx?folder=74537132-f7da-4bfc-9d92-c5e922cba45b&file=call_pilot_reference.pdf
  10. phoneguy427

    Greetings! I have setup "Outboun

    Try calling internally from a different extension to your x314, getting your greeting and pressing 7 to see what happens? Your call should go out. It's been a while but I think when you're in your mailbox admin and press 8 there is an option to turn transfer on and off. Are you using call pilot...
  11. phoneguy427

    Greetings! I have setup "Outboun

    If you call in to your AA and enter your ext, to use outbound transfer you need to press 7 when your greeting plays I believe. Are your lines in a pool? Are the lines set to supervised? I'm not sure where you are seeing Unassigned. www.linkedin.com/in/Phoneguy427
  12. phoneguy427

    External call transfer questions

    You have to make sure that under line programming the lines are set to supervised, also I think there may be a link at co setting. It's been a while sinced I played with this. www.linkedin.com/in/Phoneguy427
  13. phoneguy427

    Nortel MICS connected to Call Pilot

    Is set relocation on, if so turn it off, unplug the vm, then change the dn. Then plug the vm back in and see if that fixes it. www.linkedin.com/in/Phoneguy427
  14. phoneguy427

    DR4 to XC 7.1 too big of a jump?

    I usually went from 4 to 4.1 then to 6.1 and finally 7.1. This will keep all the programming most of the time. www.linkedin.com/in/Phoneguy427
  15. phoneguy427

    Norstar night service

    Does the phone have any answer dn's assigned? Does the display show anything when it chirps? www.linkedin.com/in/Phoneguy427

Part and Inventory Search

Back
Top