Recent content by phonedudette

twmoody If you are using Nortel M1 opt 11 - 81c. Try using D100 or SL100 interface on the M1 side. The M1 should be set as the URS. If using Cisco CM set the interface to DMS100 and make it the NET. Make sure to configure the trunks group and make sure the NCOS is set high enough to allow...

twmoody Despite what cisco says, the NI-2 interface does not seem to work. Print this thread, the responses I received from it help me. What is your PBX switch type? What is the IP switch type? I should be able to help you figure out your problem.

Ok, so I don't need QSIG (guess Nortel was trying to get more money as usual. Thanks to you all. I really appreciate your help. I am going to check all my config. again, and again until I figure this out. Thanks again

Thank You, to all of you for your continued support with this issue.

EJPTELECOM I have the M1 at USR and External Clocking. Currently the only problem I am having is that the Cisco CM is unable to make outgoing local or long distance etc. Do you have any ideas on getting this to work. Also, I see you are using SL100 Interface on the M1, what is the...

bpg1 4-digit dialing both ways are connecting. External Incoming calls to the Cisco are connecting. Cisco CM can not make any Local, LD, or location code calls. The M1 does not know what to do with the digits being sent to it. 9 972 9 214, etc 9 1 xxx xxx xxxx Location code 8xxxx Do I...

bpg1 This is what I have programmed in the M1 REQ PRT TYPE ADAN DCH 2 ADAN DCH 2 CTYP MSDL GRP 1 DNUM 13 PORT 3 DES CISCOVOIP USR PRI DCHL 50 OTBF 64 PARM RS422 DTE DRAT 64KC CLOK EXT IFC D100 SIDE USR CNEG 1 RLS ID ** RCAP ND2 T200 3...

bpg1 No, it's still not working. Only 4-digit dialing between the M1 and Call Manager is working. No incoming or outgoing calls are completing.

bpg1 Thanks for your help...the AC2 in the M1 is set to 8. 8 is the location code for the followed by the 4 digit ext.

Ok, this is the request from the CISCO group. They are wanting Station to Station Calls (4-digit dialing)this is working between both systems. Cisco CM have route patterns that send 4 digits, (e.i. 1xxx, 5xxx and 6xxx) stations are dialed. This covers all stations at site A. Outbound Calls...

bpg1 - where would you find the prompt for ART and does the cisco have to have a route programmed through it to delivery calls out to the pbx. Thanks.

I need help configuring an ISDN PRI TIE Trunked to CISCO Catalyst 6000 Gateway. So far I have configured loop in ld 17, Configured DCH in ld 17, Configured route in ld 16 and configured trunks in ld 14. Also configured CDP/DSC. The problem is that I am able to complete calls via 4-digit...