Recent content by phitzer

Ok I know I need the routes pointing at ips and target lines, routes , dest codes... Do I need to also build branch office tunnels under data services? Or is this only if the BCM is on the WAN? I really thank for the help as this is the first BCM I've had to network toghether.

routing tables? or static routes? or do I need to config both?

I have a BCM 4.0 and 2 BCM 50 rls 2. I have point to point t1's from the 400 network both 50 networks, and all BCMs are on the LAN behind routers. Just purchassed MCDN and VOIP trunks, my question is will I need to build static routes under IPsec VPN? Or can I do all the programming from IP...

links sys can support vpn it depend s on the router model. Why not eliminate the linksys router and just use the pix with a p and p switch?

unfortunatly I am the system admin. We have 9 sites that I take care of, eight of them are norstar ICS and BCMs. I have a small garage with a partner acs. Only two mailboxes on system. One guy left and i neeed to reconfig mail box any help would be great!

Hello, How do I reset my mailbox password on partner mail back to default 1234?

my mistake error 1222!

BCM 400 3.7. When attemting to back up the system it looks as if it begins the back up then gives me error 1227. What does that mean???

enabled (up)

hey everyone, I have a bcm 400 been up and running strong for over a year. Love this system. We are currently looking to deploy off premise extensions via vpn. Just looking for a little insight. My question is what is the best way to connect to the bcm via the www. My bcm is now behind my...

where does one aquire said patches?

I made some changes to a the call pilot on a bcm 400. All the greeting are still there but when you dial an extension it says please record name after the tone.Any ideas

is there a special tool needed to take apart a T 7316e set. I removed all screws but there is one round "lug" holding the set together.

well 5 minutes playing with the routes and destination codes I got it! is this the best way? To access lines i set up the key (labled line pool) for external auto dial to the destination code.

Hello, we have a MICS 7.0 just we access lines from line pool. Our service provider requires us to dial 9 then the number. Is there a way to burry the 9.