Recent content by perseusc

this is what some commands show, type at the server's side router OBR_LAB_RTRB#show ipx interface Ethernet0 is up, line protocol is up IPX protocol processing disabled Serial0 is up, line protocol is up IPX protocol processing disabled Serial1 is administratively down, line protocol is...

i can ping the novell server from the remote site, encapsulation type on the server is 802.3, encapsulation type on the router's ethernet inteface is novell-ether, ipx routing, both network numbers are the same, etc. One thing i did not mention is that remote router does not seem to have ipx...

HI i have built a small cisco lab to practice with, i have them connected through the serial interfaces, one one end i have a station, swittch and routher; on the other end i have a rother, switch, station and a novell server 5.1. I have the serial link up, ip configured ( i can ping anything...

hi marvhuffaker, i checked once again on the threads section and the ones on top while the server's ulitization is high are Worker Thread Manager and Server 00:00, i am downloading the packet caputre application you suggested also. My server is a Dell Power Edge 1400SC pentium III 933 MHz dual...

Hi, i also have the same problem with a novell 5.1 server, matter of fact i've had it for more than two months...it usually happens at the same time of day, my utlization reches 30% affecting all users conected to the server, i checked the busiest threads as marvhuffaker suggested, and i also...

i finally left novell run on the IDE driver and after that i enabled the scsi controller and created a separate volume. i want to thank you all for your help, it sure was helpful regards

at this point, i installed novell on an IDE disk, after i finished i went into nwconfig and added tried to install the controller, it gave a slot number of 10012 but the result was the same, it would not load; i loaded scsihd.cdm first and then tried to load the controller again and it worked...

hi all i am trying to setup an IBM Xseries 235 box with novell 5.0, this box comes with an ultra320 disk controller, i downloaded the drivers for this card and when i try to install it through novell, it does not give me an slot number, normally it would give you an slot # but its not happening...