Recent content by PEPBUSTER

I need some help. I have three sites that have Callpilot 702t with 4.04 software. One has approx 7000 mailboxes and the others about 1000. They are connected to Nortel 4.0 PBXs. I have 3 Callpilot 200i that have about 100 mailboxes on each, that are also 4.04. The callpilots that are 702t, 4.04...

Try to reinstall your language prompts in Config Wizard and reboot sever. Sounds far fetched but it worked in the field for me. Also a while back Nortel was giving a free upgrade to 2.0 on a bulletin from 1.07. Good Luck

Chuckman, ran into same problem on a Miran 3 card on Succession 1000m system. I reseat the card and that cleared trouble with static. For a backup, look at the Merl 3.00, NTP 553-3001-112 pg 122 for the procedure. Also, pg 266 for the replacement of Miran. One more thing you might want to...

Feature 5 is the feature code for a flash. It also can be programmed under a button on your sets. Feature*3 press button to program Feature 5 RLS Now that button is programmed

John my Nortel School books says to insert the Callpilot Server cd in the computer where you plan to install Apps Builder. Then run appbuilder.exe, Then follow the instructions in the installation program.

I have run into this problem many of times in the field. Have your far end provider reset the B-channels on the T1. This will most likely fix the trouble. I always get them to do an end-to-end test and they say everything is ok, when really you can't make a call. Sometimes the channels will say...

John have question on MIran 3. Have you ever run into static on annoucements on these cards? I'm going to reseat and reset cards next week on a maintance window. After i'm upgrading firmware to 30m08 on cards. I can also administor the cards through a GUI interface. Also getting static on Cards...