Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Wanet Telecoms Ltd on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by pcwizlondon
-
Paging on 3904 set
Unfortunately this is the only 3904 we have. I have replaced it with a 3903 as the same DN but have the same results. I have also switched TN's. When I had the 3903 at that jack I could program it as a different DN and it worked. If I had the DN set to a 200x number it would not work.- pcwizlondon
- Post #9
- Forum: Nortel: CS1000 (Meridian) systems
-
Paging on 3904 set
I tried MANO=YES but no luck. I can page at the second site from other phones just not this one 3904.- pcwizlondon
- Post #5
- Forum: Nortel: CS1000 (Meridian) systems
-
Paging on 3904 set
Yes there is an analog card and sets at the remote site. I can page from ANY other digital or analog site with CLS UNR set. I just can't page to ACOD 86 wiht this 3904 at extension 2001. I will check if EES is turned on.- pcwizlondon
- Post #3
- Forum: Nortel: CS1000 (Meridian) systems
-
Paging on 3904 set
We have two facilites linked with a T1 and have a Valcom V-2003 paging controller at each site programmed as a COT trunk. On our only 3904 set I can't break the valcom tone on ONE of the units. Everything works fine on ACOD 85 but I can't break tone on ACOD 86. I have checked the route and trk...- pcwizlondon
- Thread
- Replies: 12
- Forum: Nortel: CS1000 (Meridian) systems
