Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by PBXII

  1. PBXII

    ISDN BRI with 23 members showing OOS/FE Idle

    No new configuration has been done to the DS1 and I was able to do a successful internal loop back to the CSU/SDU another good indication that it's not with our equipment. I have asked them to dispatch one of their techs to trouble shoot the issue. (Which after much grumbling they have agreed...
  2. PBXII

    ISDN BRI with 23 members showing OOS/FE Idle

    No- They are all still showing Out of Servvice/ Far End OOS/FE-idle. (
  3. PBXII

    ISDN BRI with 23 members showing OOS/FE Idle

    That's what I thought, I have called our provider and told them we are not receiving any signals from them on our D channel and they are currently re-testing the circuit. I wanted to make sure; I did everything I could to ensure the issue was not on our end. Thanks for your help and will let u...
  4. PBXII

    ISDN BRI with 23 members showing OOS/FE Idle

    TEST RESULTS Port Maintenance Name Alt. Name Test No. Result Error Code 01D19 UDS1-BD 138 PASS 01D19 UDS1-BD 139 PASS 01D19 UDS1-BD 140 PASS 01D19 UDS1-BD...
  5. PBXII

    ISDN BRI with 23 members showing OOS/FE Idle

    Switch: G3si V11 Issue: We have an ISDN BRI with 23 members showing OOS/FE Idle. I have called our provider and said they are testing clean. -I have the tested the Circuit pack -I have busyout and released the board. 06/24 01D1901 OOS/FE-PINS-idle no 06/25 01D1902...
  6. PBXII

    Trunk Group Member State/Disconnected?

    I have no dial tone at the de-marc I will open a ticket with our LEC. Thanks
  7. PBXII

    Trunk Group Member State/Disconnected?

    It's a 2 way Voice Loop Start
  8. PBXII

    Trunk Group Member State/Disconnected?

    Loop Start
  9. PBXII

    Trunk Group Member State/Disconnected?

    We have a port showing disconnected on our CO trunk. Test results are showing Error Code 1005. Does anyone know this error code or where I can reference it? Thank You TRUNK GROUP STATUS Member Port Service State Mtce Connected Ports Busy...
  10. PBXII

    Command to view call path? )

    Yes I could not remember the command. List trace station did the trick. Thank you!
  11. PBXII

    Command to view call path? )

    Switch G3si V10 Issue: I need to see which trunk group a call is going over. I know there is a command that I can use and then dial a number from the phone and it will display the call route. Question: What is the command that is used to view the routing or call path? Thank you!
  12. PBXII

    Display current software release?

    That is what I thought, however under System Verification...View installed the only options I am given are the ones below? I do not have the view installed software option. Verify System Installation x Verify System Status x Verify CPU CMOS Settings x View CPU CMOS Settings...
  13. PBXII

    London Voice Carrier Options

    We have used Global crossing and they have always done a good job.
  14. PBXII

    Display current software release?

    What is the command to display our current software relase we are currently using on our Intuity Audix? I am having a brain freeze and cannot remember. THANK YOU!!
  15. PBXII

    Analog Phone System Parameter/COR?

    Update: Changing the phone type from a 2500 to K2500 worked. :) Thanks for the assistance.
See more

Part and Inventory Search

Back
Top