Recent content by paulhung

Hi everyone, Just a logistics question. I'm planning to replace our equipment sometime around 2010 with new blade servers. To adequately support them, I used the APC configurator which suggested a Symmetra LX 16kVA with an additional "Extended Run RM w/3 SYBT5" battery. Now, the last time I...

Hi Everyone, New to Javascript so please forgive the messiness, but I am going nuts over trying to get the following to work in Firefox. It seems to work just fine in IE. I believe it's a matter of the GetElementsByTagName method? Appreciate any help. Thanks. Paul <div...

Thanks everyone. I now have some of these unwanted calls being forwarded to an unending recording of choice Simon Cowell criticisms.

Hello everyone, Someone here has been annoyed a few too many times from automated sales calls and is looking to find some vengeful satisfaction by sending those calls into a line that simply allows the sales call to continue until the other party disconnects. So far, I have recommended that...

Hello everyone, I was wondering if anyone has had any experience with setting up VPNRemote with a Juniper Secure Access appliance... in my specific instance I am using a SA700 for SSL VPN to our LAN and would like to have our 4620 SW IP phones working on it. Thanks, Paul

Hi everyone, Not sure where to post this question, but since I am running on IP Office, I'd try here. We have a couple of fax machines running from the POTS lines that have been receiving an annoying amount of junk faxes. I was wondering if anyone has had any success in reducing the number of...

Trying to script the mapping of a network drive with the username and password in the command line. Looks something like this: net use M: \\x.x.x.x\share pass&word /user:jschmoe However, the following error would result: System error 1326 has occurred. Logon failure: unknown user...

Make sure you have the latest HotSync software (4.1.4e I believe). Sync the old Treo first to back up all the information for the other agent, then with the correct Treo for that agent just sync and point it to the profile for that agent. It should restore all of the information for him. On...

Hi everyone, Does anyone know if it is possible to get an up-to-date version of a file (e.g. spreadsheet) located on my desktop without the use of a VPN? Typically, I would sync the file when my Treo 650 is physically on the HotSync dock, but I'm on the road alot so remote access to the file...

Hello everyone, Before I potentially waste a few hundred bucks, does anyone know if it is possible to upgrade Visual Studio from 2002 to 2005 with the VS.Net 2005 Upgrade? Or will I have to buy the full VS.Net 2005 package? Thanks, Paul

The connectors have housings shaped like an upper case "B" so that they can only fit one way. I'm not sure what caused the problem, however normally when I have connected these batteries there would be a slight spark, not a massive one like this that melted the connectors.

I just recently purchased an APC SmartUPS 2200RMXL3U along with the external battery pack (SU48R3XLBP). Right after unpacking and mounting in the rack, I connected the batteries in each, then proceeded to connect the external battery pack to the UPS. What happened next was shocking. [afro]...

For future reference, the answer is yes. You can take the SDLT320 out of the 110T casing and throw it into the 114T enclosure.

Hello, I am looking to obtain two SU2200RMXL units each with a SU48R3XLBP battery pack and use them in a 2*N setup for 4 Dell Poweredge 2850 servers with dual power supplies in each. Am I right in thinking that having the UPS Network Management Card in each UPS will allow me to perform a...

As far as I know, Netscreen/Juniper requires a support contract for updates. It's been a debatable issue with some people, but that's how Netscreen has been doing it for a while. I've had to buy extended support contracts for Netscreens before through my vendor, much to the dismay of my...