Recent content by patsfanmat

Thank you Kyle! So I need them both? Is there anything else I need to confirm?

We are looking to add a handful of IP Phones 4610SW to our system, and I believe we have 5-10 IP Phone licenses, but I'm not sure what if any hardware/circuit packs are required. We do have a TN799DP installed, but do we need anything else like maybe a TN2302AP? Thank you, MJ

Hello, I have a client that has a BCM400 PBX with a legacy PRI through AT&T. AT&T is talking about switching them to BVOIP or IP/FLEX and they are wondering what CODEC the BCM uses. His E-mail is below. Our engineering has a question regarding the IP Toll Free implementation. Do you know...

A client of our recently switched dialtone providers from AT&T to XO and now the time keeps changing on the partner system. They have a (F59) PACSR7.09I0 Any ideas. #128 is not an option for us. Thanks, Matt

We have a client running an IP406V2 6.1. We recently added Avaya CCR. We are trying to display the following on the two PC wall boards... Total number of outgoing calls for every agent (40-50) Total talk time for all agents. I know Avaya CCR is primarily used for incoming reporting/stats, but...

So I know this question has been mentioned before, but I'm in a real tough spot. We have two activations this week both Merlin Legend/Magix systems. I had to cancel the 1st attempt to activate on Cbeyond as the only "Switch Type" I could use that would allow me to make outgoing calls was...

I've had a customer where we installed an IP Office 406 v2 and 3 modules that were a DIG30, Analog 30 and a POTS 16. A month or so after install, the Analog 30 and POTS 16 modules lost it's link to the controller. Tried rebooting several times but could not restore the link. It would constantly...

I've had a customer where we installed an IP Office 406 v2 and 3 modules that were a DIG30, Analog 30 and a POTS 16. A month or so after install, the Analog 30 and POTS 16 modules lost it's link to the controller. Tried rebooting several times but could not restore the link. It would constantly...

yes! thats what I tried, thanks for your help, but that is what wasn't working.

R6, And this is the 1st time I have came accross a card with that description on it.

I am using the Lucent formated card... This card had a different description on it though. "Default Translations Card" Instead of "Memory Card

Anyone know the difference? I have tried (3) different (4) MB Memory Cards and none of them work. The (4) MB card that they have is J58890TG-1, L19 601835176 What is this Default Translations card?