Recent content by o3rat

Hi, I want to host a server for a half-life MOD and in order to do so i need to forward for 27015. I use this commmand; ip nat inside source static [tcp or udp] [IP] [PORT #] interface e1/0 [PORT #] My set up is [ Modem ]----------e1/0[ Router ]e/0-----[inisde network] Current...

i have a cisco 2600, i have: -network = 192.168.1.0/24 -defualt gateway = 168.168.1.1 I have a DHCP running on the network, which seems to be working fine. there is also a NAT running on this network. Eveytime the DHCP issues an IP in which the last octet is odd the Host cannot exit the...

I can exit 'rommon' mode by entering the command "reset" then "boot" my Configuration Register is 0x80C2... how do i make it 0x2102?

Ok, i have a 2610 and two ehternet ports in use. everything works fine; NAT works, i can ping both interfaces, i can telnet, internet connectivity etc. But there is one slight problem, every so often the router will deciede to relaod itself and enter the 'rommon' mode. i cant figure out why, it...

I just configure my 2610, its running DHCP and a NAT fine and i can ping both interfaces[ e1/0 69.47.17.34/20 and e0/0 192.168.1.1/24]. I can use the internet and email services. I can telnet the router from within the network, but not from the outside. This is my current config: Current...

I have a cisco 2610 with two ethernet modules (one is on a module.) And my topology is like this: [CABLE MODEM]-------[e1/0 Cisco 2610 e0/0]------[LAN] ^ ^ | | ethernet...

Is there a WIc for a cable modem (rj-45) on the 2600 series?

What module do i need to add another erthernet, for a cable modem, port to my cisco 2610 router?

would this be the right module to get in order to have this 2 ethernet interface "Cisco WIC-1DSU-56/64K CSU/DSU"?

Well, im jsut getting into this Cisco stuff and i was wondering how i would go abotu and a connect a Cable modem , from and ISP (like comcast), to a Cisco 2610? Do i need a any additional hardware modules? I know the stock ports are console, aux and 1 ethernet.