Recent content by nwaterworth

Thanks! That's good news. Now just waiting on telco to install the line.

Fixed it with an upgrade to 11.3. Thanks.

Hi, I'm trying to connect to a very remote site via a BT Megastream 1Mb private circuit in the UK. Site is scheduled to be broadband enabled in March next year, so I've bought a couple of very cheap 2503 routers to hopefully do the job short term. Can anyone confirm if this will work (X.21...

Thanks for your reply. The second 2503 router turned up today running IOS 11.3, as opposed to 11.2. No problems there with the IP, so I think an upgrade is a good first step. I'm running the config from the prompts after a write erase/reload. Thanks for the help.

Hi, Just acquired a 2503 router which I need short term, and it won't accept any IPs on the internal subnet it's attached to. Intended address is 128.0.16.x with mask 255.255.240.0. The config gives %Bad IP address% before it's even asked about masking. IOS is v11.2. 128.1.16.x is fine. I...

Thanks, A full Office 2000 reinstall and SP3 got rid of the error message. My work machine flips out sometimes, as it's mostly used as a test bed, and it wasn't allowing me to install SP3. I'd previously read a MSKB article stating that the problem was fixed with SR-1/1a, but eventually found...

I'm trying to scan an Outlook folder which is populated by a third party plug-in, and which uses custom forms. When I scan the folder, the first time a message item property is referenced for each message, an error pops up. If I click "OK", all the PEMs are available. Does anyone...