Recent content by nuklhead

I am having the exact issue on 2 sites with 9.1.4.0 Build 137. Has there been any resolution to the issue? I have 3 sites with the same set up, but only one is connecting using EOC. The other 2 are fiber. Only 1 fiber site has the same issue. I am equally at my wits end....We cut over on...

I have experienced the same issue with R7 as well. Turns out I had the wav file in my manager application folder on the PC I was using to manage several systems. The file migrated on to multiple systems. Search the PC you have manager loaded on to be sure that wav file is not in the active...

That is the problem, I had the customer reboot the system. The time adjustment in the VM to the correct system time seems to have corrected the MWL lamp issue. We wil check the error logs again in the morning. Thanks for the responses.

Yes, everything has been moved up 8 ports and all calling groups etc renumbered. I used maintenance to check the actual logical id and renumbered extension. Some are in the 7XXX range and some are in 5XXX range for whatever reason. It is irrellevant to this issue as it was working in the...

On the Merlin Legend you renumber the extension to match the receive digits sent by the service provider. They are most likely sending 2 or 3 digits. to make both ring you could program a primary coverage button on the other extension.

I have a Merlin Legend 7.0 with Merlin Messaging 4.0. We needed more digital telephones so we took out 2 -012 TR and installed 2 016 MLX. Realizing we were beyond the 200 port mark and could no longer assign extensions, we swapped an 008MLX for the 016MLX and renumberd the boards etc. Checked...

Curly cord is the only one I would listen to dude...He as I have been there and done that. It also keeps you from having to outpulse a line or pool access code (9). Only works for copper, not PRI (there is no dial tone on PRI)

Feature 85 aka DND. All it does is turn off the ringer. It will still flash. Feature #85 to cancel DND

To add a transfer, First build a CCR tree, then just have the AA answer the lines according to the Norstar schedule for night if you put the VM DN in the ring group designated for night. OR use the VM schedules, either way. Then have the AA pass the call off to the CCR of your choice...

I have a CP150 1.5? in on elocation and CP150 2.0 in another. After setting up a VPN through a firebox router, the GUI or Web interface locks up. The only way I have to unlock it remotely is to telnet in and reboot the VM. It works fine until I logout and let it sit for a while, then it locks...

I have a similar issue... Will this work with a Legend 7.0? The customer needs the ANI to sort billing for each company from the LD provider. I have the number to send set as base plus intercom. Only trouble is that the executives do not want their individual DID displayed to every call they...

I found the "On" button for time control and cover control inhibit. I also changed a few other things with my delay extension and it now works. Thanks Again!!

Another note,, you do know changing the DN will not change the Target line appearance... Set relocation was a good recommendation.

the way a copper DID is set up, the number to the DID is dialed, the trunk is set to auto answer, then the telco repulses the last four or three or two digits once the line is seized by your switch. Was it working before and just stopped or is this a new change to the switch?

It has three PRI's A,B,C,D trunk groups and you can put the DTI cards in two places on MICS1 and 2 "off core" places, specifically slot 1 in a 12X0 connected Via fiber MOD 03-08. It Nulls out the slot 2 and 3 for each of the 12X0 trunk mods configured this way. I think you can have 3 active at...