Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by NuggiFirst
-
Upgrading a 403DT
I have absolutely no problems in going from 2.1 to 2.99 to 3.2! The 2.99 replaces the boot-loader so that 3.2 can be loaded.- NuggiFirst
- Post #10
- Forum: Avaya: IP Office
-
-
Upgrading a 403DT
First upgrade it to the 2.99 build. Then the 3.2(54) build. Nice and easy ;-)- NuggiFirst
- Post #2
- Forum: Avaya: IP Office
-
Phone over VPN No Display
Have you disabled "H323 fixup" ?? If not, then i bet that's why the phone is registered wrong!- NuggiFirst
- Post #5
- Forum: Avaya: IP Office
-
Phone over VPN No Display
Disable "H323 fixup" in the Pix, and maybe the ASA :) That's it!- NuggiFirst
- Post #3
- Forum: Avaya: IP Office
-
two IPO connected via tunnel - how?
About multiple voice-servers in SCN enviroment: We have systems running with SCN enabled, and multiple VM Pro servers at different locations. We haven't run in to specific issues in this scenario. But as mentioned above, it's not supported by Avaya...- NuggiFirst
- Post #19
- Forum: Avaya: IP Office
-
two IPO connected via tunnel - how?
It should work fine with those extension numbers! I would use this setup: Create an IP route for the other site Now check that you can ping both IPO's from the remote sites. Make a VoIP-line with the following settings: Line number: Use a number that's different from the other lines...- NuggiFirst
- Post #14
- Forum: Avaya: IP Office
-
two IPO connected via tunnel - how?
one error: "Gateway" on the VOIP-tab should not be set to the local gateway, it should be set to the IPO in the other end.- NuggiFirst
- Post #8
- Forum: Avaya: IP Office
-
412 from 1.4 to 3.2
All released 412's can run the the newest versions :)- NuggiFirst
- Post #4
- Forum: Avaya: IP Office
-
Help Button for Call Center
What about the "Display msg" function? Haven't had a chance to play with it in this scenario though.- NuggiFirst
- Post #2
- Forum: Avaya: IP Office
-
406v2 memory upgrades?
Maybe it's the future upgrade to 4.x he's worried about. Sadly, 4.x is a no go for pre PCS06 V2's, and some PCS07's Funny thing though: All the PCS07's I've seen has been 64MB versions.- NuggiFirst
- Post #3
- Forum: Avaya: IP Office
-
Upgrade IP412 1.3 --> 3.2
We also have a couple of INDeX guys.... But they have trown away that old routine now! :) We only use intermediate steps if the loader needs an upgrade. Works perfect!- NuggiFirst
- Post #24
- Forum: Avaya: IP Office
-
VOIP Help
One of my observations: Many "network-only" guys are very unexperienced in working with QoS. We have just had a case, also with Cisco equipment involved, where the Cisco-guys had major problems in getting the QoS working properly. We prefer equipment where we can monitor the routers, and...- NuggiFirst
- Post #2
- Forum: Avaya: IP Office
-
Upgrade IP412 1.3 --> 3.2
Nice to know that it (almost) worked as planned :)- NuggiFirst
- Post #22
- Forum: Avaya: IP Office
-
Upgrade IP412 1.3 --> 3.2
We haven't seen any problems with 412's running the newest versions. That includes some of the first 412's out there, installed when 1.2 was GA. We haven't seen problems on 403DT's running 3.2 either. We haven't seen any documentation stating that "early" boxes, 403DT for instance, should have...- NuggiFirst
- Post #20
- Forum: Avaya: IP Office
