Recent content by NORTEL

I had that problem once I don't remember if it was the same code. But it would not let me add the dn to another tn because the other phone had a auto answer button.

Can you also set up hyperterminal for a star talk mini.Once you are hooked up are there certain keys you have to go to.Or is there something you have to type in.

I have older software but I believe it would do the same. in Ld 11 cls put in FITA (FLEXIBLE INCOMEING TONES ALLOWED) It won't ring but will have tones until you pick up or it goes to voice mail. You will know for sure you have another call.

Thanks for the info. What I found was for some reason something locked up. I turned off the power on the system and turned it back on right away and it cleared my problem.

Push feature 984 log prompt comes on put in system password 102000 or whatever press ok shows date press next untill you get to time press change enter hrs and minutes press am pm display shows time again hit release that should do it the newer systems star talk time is updated with phone time

Then you should go into admin feature** 23646 then 23646 again press second button down on right and get names press top right button and get set names press top right button again get show set put in intercom number of set you want it will show (bob or whoever ) press change and type in new...

You have changed the name in the company directory. Now what you need to do is go to that persons phone and record the name in the company directory. 1. feature 981 2. that persons password 3.press 8 4.press 1 this will allow that person to (record)the name in the company directory

STAR TALK AND STAR TALK MINI You would go into capabilities in administration. Then set abilities, then set intercom number.Then go to forward on busy and forward it to your star talk voice mail number ie 44, or 244 or whatever number was assigned to voice mail, Then go to forward no answer and...

You have to go into load 21 REQ PRINT TYPE CDB CUST 0-99 YOUR CUSTOMER NUMBER ON THE PRINTOUT NIT1 IS WHAT TO LOOK FOR THAT NUMBER WILL BE YOUR NIGHT NUMBER

Everything will be determined by the speed you are running 328 feet should be max for cat 5. Proper termination and running of the wire make a large impact on performance. Good luck

The partner system in question had 204 modules. What I found is that the system must have taken some stray voltage. I pulled the plug on the system and it cleared the problem. The nicad battery held it's memory so everything was fine

mls 12 phones when two lines are in use you cannot access the other two lines from any other phone even though they are programmed on the other phones.Intercom won't work either.

I have a merlin plus circa 1988 system. When two calls are placed on hold I cannot access any other of the working lines. I can access the other lines only when two calls are not placed on hold???

PHONY According to national electrical code article 300-22. The only wireing allowed in ducts or plenums is for wireing for devices for that duct or plenum. Possibly you can go up through a pipe outside of the building and into a attic or closet. techy