Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Nico75

  1. Nico75

    S87xx / G350 / BRI issue in France

    Hi technical community ! Does somebody on the globe succeeded in configuring G250 BRI when the carrier provides BRI whith Layer1 non stable ? Here, in France the BRI are always provided with a layer 1 non stable, that means after 120 sec of inactivity, the clock signal is no more transmitted...
  2. Nico75

    VMPro PC Hangs

    Hi, We got the same issue. One of my BP implemented a VMPro with a lot of chained assisted transfers. VMPro worked fine for few hours and then the PC "freezed",becoming very slow. VMPro process showed 50 or 99% CPU activity. BP installed VMPro in another PC. Same problem! Both PC were XP Pro...
  3. Nico75

    RSDI lines

    Hi Jorgeo, Do Colt generates a permanent clock signal ("layer1 stable") over the ISDN BRI ("RDCI" in spanish)? However, run a trace with SystemMonitor, and look for "DownGlitch" errors. Under certain circunstances, BRI interfaces may reset the DS bus.
  4. Nico75

    Anybody done the IPO + exchange 2007 UM yet ?

    One of my BPs tried w/ MP114 and it works! Outlook agendas can be checked & modified from a phone, etc... IPO and Exchange 2007 need an MP114 to work together because IPO doesn't support SIP end-point. Unfortunately, MS EX2007 has to act as a SIP end-point w/ IPO. MP114 delivers FXO ports which...
  5. Nico75

    CTI Wave Driver

    Hi, LineMonitorDigits method doesn't work with WAV users. This is a known issue for us. (cf Tech Bulletin 80) I've asked Tier4 for both tracking number & resolution date. I hope it'll be adressed with next maintenance release. Nicolas RAYNER. Avaya France.
  6. Nico75

    VM Pro - GoTo Action

    Hi guys, The VMPro GoTo Action allows you to connect a caller to another module or start point. You can select either a start point or a system variable as destination of the GoTo action. If you select a start point, it works fine. If you select a system variable (such as $CLI or $VAR), it...
See more

Part and Inventory Search

Back
Top