Recent content by NickCheung

Thanks Fisher, The concern is only one end is Cisco Router. Another end is a Riverstone router. So if this PPP multilink is only applied for Cisco. I am afriad if the config is ok. Thanks Nick ::-(

Thanks Fisher, 2 circuits are using PPP. If I use PPP Multilink, will the loop still there? Could you give me a sample config? Thanks again Nick ::-)

Dear, I want to bridge traffic from a 2501 (one ethernet port) to a riverstone router over 2 T1. Is the command "bridge-group xxx circuit-group xxx" Cisco proprietary? As I know I can¡¦t config same bridge group for two serial interfaces. This will cause looping. How can I use both...

Hi My WAN provide offer me a ethernet MAN network to connect our remote branchs and Data center where we are running Decnet and IP. If I want to keep frame relay as backup link. How can I configure my Cisco 7502 and 2061 router to run both Decnet and IP traffic? If I configure bridge mode, if...

Thanks Mike, Since I will subscribe two ethernet Internet access from one ISP, I concern the links availibility rather than the routers and I only got one 36xx router. So can I do it in one router? Thanks

Can I do the HSRP in one 36xx router? e.g E1 E2 | | | | |----------| | Router | HSRP |----------| | | E3