Recent content by Nibbio

Hello all! Is it possible to activate Call By Call statistic in Avaya CCE? I'm not very satisfied of integrated reporting.... Thanks!

Md110 BC13: i try to setup CIL output via ehternet interface and work well. Is it possible to send to output only outgoing call (only "M" call routed via LCR) My billing application doesn't need to receive internal or incoming records. Tank you

My One-box IVR need to transfer an external incoming call, to another external destination. It work very well but system wait the answer from external number. If I try to transfer before answer, call return to IVR. Why? Thanks

Md110 Bc09, connect via qsig with pabx A (Tenovis integral 55) and pabx B (Cisco Call Manager). Cisco can call Tenovis but non vice-versa. Tenovis use 1040xxxx where xxxx is Cisco Extension). I Activate q931 debug in cisco but I dont'receive any setup from Md110. Tenovis can call any Md110...

Thank mundus...I'll try but I think will be ok!!

I think is not big enough....i must use pnr

Hi, all. I need some infos about dialing Plan. I'm going to connect Md110 with Avaya Cammonication Manager via q-sig link. Some users will migrate from Md110 to Avaya. Simple solution should be dedicate 2xxx extension to one site and 3xxx to another and define 2xxx and 3xxx as roddi each other...

I tried bu unfortunatly doesn'work...

Hello! I'm testing qsig between Md110 (bc9) and Avaya Comm Manager I can forward call from Avaya to Ericsson but no viceversa. When I try to dial: *21*8100# (8100 is Avaya ext.) the Ericsson phone display: "Wrong format". <RODAP:ROU=56; ROUTE DATA ROU TYPE VARC VARI VARO...

I understand. So, traffic between different network (no visible between them) is possible only if I have 2 gatekeeper on two LIM, and the call is connected by sys-link. Now is clear. Tanks!!

No, Gatekeeper is in DMZ, in another network. Netw a: 10.142.177.0/24 Netw b: 10.142.111.0/24 DMZ: 128.1.14.0/24 Routing to A and DMZ= ok Routing to B and DMZ= ok Routing to A and B =NO!

Ok. Can you give me other info about this configuration? Is a system parameter o a gatekeeper parameter? How can configured?

I need information about RTP packet sent from a Phone to another, in different network (hub and spoke) Explain: Phone A is in network A Phone B is in network B Md110 Gatekeeper is in DMZ network Network A and B cannot communicate each other but only with DMZ, (where are application server like...

Can someone explain me how Dial-back service work, and if is it available in BC9? Thanks!!

Md 110 BC9: Is it possible to hide the TRA number on digital telephone display? I don't want see the real number dialed. Thank'S