Recent content by newifu

I figure it out. It actually updated but it doesn't just copy the master zone file but I think it copies a running instance from master. The records are sorted, comments are removed, etc

I have one master DNS server and 2 slave servers. all running on Fedora. After I add a record and change the serial# on a master zone file, the salves zone file serial# get updated, the timestamp is updated, but the rest content of the zone file remain the old version. the new added record is...

Thanks, I overlook the "Do not use SBS Backup". For the NTbackup, I didn't see any job there. anyway I cancel it by the "Do not use SBS Backup".

I have Backup Exec running on a SBS 2003 box. Today I wanted to test the SBS backup configuration, so I setup a backup to disk job with the SBS wizard. Now I can't find a way to remove this job. Any help would be appreciated.

If F**266344 I get 4 menu options: A.Configuration B.General Admin C.Set Copy D.Maintenance I remember someone said this is a very old software.

You mean MICS1.1 is higher than 4.1? I see a label on Moduler ICS: NNTM040D0199 NT7853FA-93 I also see a label on the internal sode of the box cover: NT7B53FA Rxx Norstar 0 X 32 KSU, W 7.0 software If my version is above 4.1 why I always...

I am trying to forward incoming calls on an extension to an extenal cell number. I setup a route and DEST Codes, I always get the Invalid number error.According to the FAQ and many threads here , it has to be version 4.1 or above. My question is how to show the version number from the phone?I go...

My clean jobs are most successful, but the message is still there

Thanks

We bought a APC SmartUPS 2200 which will be located on the bottom of a rack. since we are moving a bunch of servers to the rack, I am concerning wheather UPS interferes with servers if I put 2 servers right above the UPS. Is there a minimum distance between UPS and machines?

Thanks, will try them.

If a server is always running in text mode, how do you access a website and download software? Do you have to bring the server to level 5? Thanks for any reply.

Thanks for the reply Lawnboy. I actually cleaned it a few times. Will do it more times and see how it goes.

After backup to a few new tapes, the drive shows "Cleanning Required", I ran cleaning job successfully, but the amber light is still on and the message is still there.The autoloader is a IBM 120/240 loader and the drive is 20/40GB DDS/4 Tape drive. How to get rid of the message? Any help wil be...

Do I need a tone tester to find out which cable corrsponding to the jack if there is no label on the jack?