Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by netprogrammer
-
router ospf 100 <- fails
Thank you to both Andy and Mark. The main problem was that I had no IP interfaces 'UP', tha't why I got the "Could not allocate router id" message. I had tried that both with and without being in the interface sub-command mode. Now ospf runs, and I have configured an Ethernet interface and a...- netprogrammer
- Post #5
- Forum: Cisco
-
router ospf 100 <- fails
When I try to install the ospf routing protocol on my Cisco 2610 with IOS Version 12.0(5), I get an error "Could not allocate router ID". I have tried all sorts of things, what am I doing wrong? Router(config)#interface ethernet 0/0 Router(config-if)#ip address 10.0.0.6 255.0.0.0...- netprogrammer
- Thread
- Replies: 5
- Forum: Cisco
