Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by netKIZ

  1. netKIZ

    ASA 5520 multi context cannot ping sub interface

    Hi - The static is in place to allow traffic destined for 192.168.100.0/24 subnet to pass from the less secure (vpn) interface to the higher secure (inside) interface. I'm not performing any NAT'ing otherwise. Yea, I did allocate the physical gi0/2 instead of the logical on the "vpn" side. I...
  2. netKIZ

    ASA 5520 multi context cannot ping sub interface

    Hi all, Working on a new 5520 in my lab. From my context "simA" cannot ping default gateway, and from my gateway router cannot ping the sub-interface IP allocated to "simA." What am I missing? Thanks in advance! From the system space, ping to the default gw IP is successful. lab-asa1# ping...
  3. netKIZ

    Solaris SNMP

    Hi, I originally posted this question under the Solaris forum, so appologies in advance for duplicating the effort. My Quesiton: Have a Sparc system running 5.8. I want my Sparc system to send a cold start trap to 192.168.1.19 when it reboots, but it is not. I added "trap 192.168.1.19" to the...
  4. netKIZ

    Solaris SNMP

    Hi - curious if anyone has experience working with SNMP on Solaris. I would expect the system to send a Cold Start snmptrap when the SNMP daemon is restarted, but I have been unsuccessful in getting that to happen in my lab. Are there any known issues with certain versions of the SNMP daemon...
  5. netKIZ

    Solaris SNMP

    Hi, Have a Sparc system running 5.8. I want my Sparc system to send a cold start trap to 192.168.1.19 when it reboots, but it is not. I added "trap 192.168.1.19" to the configuration in /etc/snmp/conf/snmpd.conf I've restarted /etc/init.d/init.snmpdx but this does not help. What am I missing...
  6. netKIZ

    Contivity IPSec Peer with Cisco PIX

    Thank you all for your replies. This issue has finally been resolved. The resolution was to set Vendor ID to disabled (thx datacomm5). We were able to leave PFS enabled on the Contivity and on the PIX we have set PFS to group 2. Thanks again!!
  7. netKIZ

    Contivity IPSec Peer with Cisco PIX

    Hi - Want to ask again if anyone has ran into this issue? Have any Contivity gurus successfuly built a VPN site-to-site IPSec tunnel with a Cisco PIX? The problem I have ran into is if the Cisco PIX initiates the tunnel, packets are not encrypted/decrypted. Would this be an access control...
  8. netKIZ

    Contivity IPSec Peer with Cisco PIX

    Hi, I have a site-to-site VPN (IPSec) tunnel between a Nortel Contivity and a Cisco PIX. Only when the tunnel is initiated from the Nortel Contivity is traffic encrypted and decrypted. If the tunnel is initiated from the Cisco PIX I cannot pass traffic. Is there a setting on the Contivity...
See more

Part and Inventory Search

Back
Top