Recent content by Netguys

If need ethernet port for CIsco 2524 then what is the solution or part number?

Thank you for your info!!I going to buy 1 of the Zoom brand name external modem, so far it have alot of people use it.

Need to find out which brand name and model are support the following Unix platform: HP-UX 11.i, Sun Solaris Ver 8 and 9, FreeBSD 4.6 or Redhat 4.5 client. and also which ISP such as AOL, Earthlink, Netzero or any other ISP able to connect use any of the Unix platform show about? If not is any...

I don't have that CD, but I did down load quality pack from Hp.com, and would it take care the Y2K problem? Thank you!!

I have install FreeBSD 4.6, total 10 time and able to be use command line. but X windows I never get it to work or open X windows and nothing in it. any one able to help for verify Xwindows part of config?

The signal from the VGA out put of the motherboard from dell is not enough to support 2 monitor, so you went to use signal boot to display 2 monitor, what about VRAM can you share more memory and try it again, so far I know of all currently model notebook use memory share from your system ram...

Another thing you can do is reset the bios, 1, unplug power cord from the power supply 2, remove the both pci and agp video card 3, take the coin battery out , and still a screw driver to both terminal of the battery on mother board. 4, Reinstall the agp card. 5, Reboot computer. 6. If you see...

You can use any pc monitor and the req is to be 76 or about hor, and 80 or more vertical refresh rate, some 19 or 21 and brand name monitor do have a higher refresh rate show about. HP-UX this is worth then Sun computer. but better graphic!!

I have a 712/60 run under UX-9.* and wonder if I upgrade it to 11i would it able to run, is any bios upgrade to fix the Y2k problem? If so where can I download the software?

never mind, i going to look it up in the book and hope to get answer!!

Me too just start it too, that is why I brought my 2524, but 2514 is easy than 2524, this is depent what you want to do, if just want learn about IOS and you can hoop up 2514 in between two PC or Unix system, also can be share you internet access and use the router as a firewall. 2524 is hard...

I am new to Cisco router, can some one help me to config this? I know this 2 wire switched just like a build in analog modem in pc, but the rest I need some one help in IOS config, thank you!!

Well!! So far some one told me it can be config into 2 IP address, 1 is the ethernet port, other is the Console port?

I just got a Cisco 2524 over the Ebay, I wonder did any one could help me out to find out which module should I buy? to set up 2 Lan in between local network, just want to do some thing simulate a computer having 2 network card.