Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by NetEng631

  1. NetEng631

    Serial Input Eroros, CRC and Aborts

    Change the clocking to line timing.
  2. NetEng631

    Event viewer not loading

    To all, I am running HPov NNM Release B.06.20 on Windows 200 Server. Currently when I lunch the NNM application the event views freezes when it begins to load the eventDB. It gets to about 14% and crashes. HPOV is still working fine. Any Ideas. Thanks for the Help NetEng
  3. NetEng631

    Network Monitoring

    I go with Ethereal for a sniffer and I use HPOV and syslog for Network Management.
  4. NetEng631

    Bridging LAN between switches

    Ok here is one way of doing it. The simplest way. You need to configure two port on each switch into VLAN 2. Then you need a cross over cable to connect each. The better way is to create a 802.1q trunk between each of the VLANs and trunk vlan 1 and 2.
  5. NetEng631

    Forgot to Assign IP to a Cat 2950

    Your going to need to send someone out there. Sorry
  6. NetEng631

    MPLS VPN problem

    I maybe wrong on this I haven't worked on MPLS in a while and I don't have access to a lap big enough to test this. Also I maybe a little off on how traceroute works. But I think your assumption of not being able to see the transit network in MPLS could be wrong. In the routing table your...
  7. NetEng631

    HSRP with two T1s different networks

    HSRP will not help you in this situation.
  8. NetEng631

    CDP

    I agree with vipergg. CDP can really help save time trouble shooting. just dont run it on any outside facing routers. The routers infront of the firewall should not run CDP.
  9. NetEng631

    Statistics without SNMP or HTTP ?

    You can write your own using perl and the Cisco:net:telnet module
  10. NetEng631

    Help needed on designing VLANs

    Cisco does not care anything about profiles. You can not do what your looking to do at this time. You can use VTP to configure based on a mac address but profiles are well outside what Cisco supports.
  11. NetEng631

    not able to view 1 external webpage

    Check the rules between the DMZ and internal network. Also check the routing.
  12. NetEng631

    Multicast Simulation Application

    Sorry Don't know any. put smartbits in google. Go to the netcomsystems page. It's a test set and it's very expensive. Neteng
  13. NetEng631

    Create multiple VLAN's on a 2948G

    You have to look on Cisco's web site and configure switch in VTP. netEng
  14. NetEng631

    Multicast Simulation Application

    The smartbits can simulate Multicast traffic. You need to by the unit and the Multicast Option.
  15. NetEng631

    Questions on a router for a DS3 w/ voice

    It's also not a greate idea to have all your circuits on one line. If the DS-3 goes down your whole office will be down. You really need atleast 8 T-1 before you consider using a DS-3. ALso you will have to pay the same charges for a lot of the port charges for the T-1's they break off. You...
See more

Part and Inventory Search

Back
Top