Recent content by NetAdmin2004

For anyone out there that runs into this issue... I think I have a few suggestions to try. I was finally able to do a cold import into VC BUT there are a few considerations you may want to review. 1. If you have multiple partitions and/or Disks, do not try and import everything at once. Start...

Okay sounds good.... Thanks for the response... I am going to give that a shot next... Ed

I have been trying to find the best way to migrate a Wndows 2003 Server running 2 sets of Dynamic Disks (C: - OS and D: - Data). This is setup for mirroring utilizing Windows 2003 built in software RAID. I read an article on VMware's KB stating a workaround is to break the mirrored volumes...

Okay thanks for the info and sorry about not posting correctly... I wasn't sure where to post since it I wasn't sure exactly what support I required... Thanks, -Ed-

Which adapter should I look at since this is supposed to be for the PBX systems and not needed to be used with an ATA adapter? The Konnexx adapters I have seen are for analog conference phones.... Thanks, Ed

Okay on the Adapter.... Thank for the info... I didn't order this phone but someone else did and threw it in my lap to figure out.... Go figure... Ha Ha! Thanks for your help... I will look into the adapter. Thanks, -Ed-

We have a Norstar.... -Ed-

We currently have the following listed in the software: M7100 M7208 M7310 M7324 T7316E -Ed-

I will give just 2616 a shot and see what happens..... The ICS I thought was the Software for connecting to the system... If I am mistaken, sorry... I am not much of a phone programmer... Hence why I need help! Ha Ha! Thanks again! -Ed-

Yes it is a PBX Nortel Meridian system. Thanks, Ed

I have a Soundstation2 from Polycom and from what I see in the manual, you need to setup as a M2616. Can someone help me out on how you do that? When I try to enter that model in the "Mdl" field in ICS, it says that it is "not a valid option for Mdl." We use ICS for our programming via a PC...

I have a T1 and a ISDN Prime circuit currently routed seperately. The ISDN Prime goes to an Adtran Atlas 550 then to the Phone Switch and the T1 goes to a Cisco 2620 Router to the firewall..... I would like to combine the two circuits onto a Cisco Router and I am not familiar with how or if you...

I believe SP1 seemed to have fixed our problem..... I will check with one of our guys to make sure and post it ASAP for you if that is not it.... Thanks!

Okay, the scavenging is set to 1 hour and just to add more info to this thread, the Exchange Server is 2003 on a Win 2003 Server box and the DC with DNS installed is a Win2K box. The DNS server Zones are set to an Active Directory Integrated zones. I figured if the Scavenging was to process...

Ha Ha! Wow, sounds like they had a serious problem with cleaning people! Who would have guessed.... Our servers are in a secured area, so that couldn't be it. I wish it was that simple.... Thanks though....