Recent content by neab

Hi What are recommended LTO2 parameters (blocksize...)when using with AIX 5.3. The LTO library is used without any commercial backup tools.

When using LT02 (IBM 3582library) without any commercial backup utilities, which aix blocksize parameter give best performance?

Guys, I am trying to save some files on a LT0 200/400G tape using the command tar cvf /dev/rmt0 and the command is not successfull, it says: tar: 0511-825 The file 'dbastarch.1130.tar.Z' is too large. I tried it on a larger tape too, but returns the same error.

Hi Issuing errpt command on my p620 (aix 5.1, ML7), i get an message error ''tmpltfile: calloc: a system call received a bad parameter'' Who can help?

Trying to install Oracle on my system p570 aix 5.2, I get this message ''Asynchronous I/O is not installed on this system. You need install to it . config it yourself using 'smit aio' or rerun the oracle root installation procedure'' Who can help?

It does not boot with CD to process upgrade at all. It hangs with O518. But it still can boot back with Aix 4.2

Hi I'm trying to upgrade AIX 4.2 to 4.33 booting from CD1 of AIX 433. But on bootprocess, the system (43P Model 150) hangs with 0518 on panel. But i still can boot on the aix 4.2 system.

I add cpu right clicking on my partition on HMC and by doing add processor. after this i perform cfgmgr on my aix session.

Hi. I've installed two partitions on my p570. I'add like to discover the processors i add (on HMC) on my AIX 5.2 Partition without rebooting. Doing cfgmgr did not make me see the processors successfully added on HMC; They are discovered after rebooting my partition. How to discover newly added...

I have a Risc server with AIX 5.2 ML5 and when I perform telnet <ip adress> <port #> (telnet 192.168.0.9 1620) from a windows station, I will get an error of this connection at 192.168.0.9 .....: unable to open a connection at host on the port 1620 : fail to connect But i can open a session...

Hi Mike the adapter is an gigabit adapter. Why must i hard set the switch to 100full?

Is it possible to set Two gateways for an adapter like this ? adress 10.1.0.99 MAS 255.255.255.0 Gateway 10.1.0.1 and 10.1.0.2 how to do it?

Think you for replay Mike. Was is with a catalyst 3550? On my aix there's no errors. The adapter looks like ok. How can i set the catalyst port speed to 100full?

Hi I'm installing an Gigabit Ethernet-SX PCI Adapter (Type 9-U)on IBM p620(AIX 5.1 ML7). I cannot get link light on my adapter. So i cannot ping network systems after configuring my ethernet adapter. But i can see tx optical light on adapter connector. The connection is done with a cisco switch...

Hi i'd like to know step by step how to configure my ibm 6400 wich have and ethernet card (with ip adress)on my AIX 5.1 system. who can help me. I get some dificulties to do this. The printer is directly connected on the network