Recent content by natesin

Andrew, You were correct. I have my firewall off, but... who knows. I plugged in another device and it works fine. Something is blocking on my laptop. Thanks so much for kicking me in the right direction! Natesin... I am Nate, for I have sinned.

Sure. I am setting up a new config and the only thing I configured so far was the VLAN1 IP and the hostname. I cannot ping from the ASA to the device on the inside, but I can ping from the host on the inside (172.23.13.100) to the ASA. Thanks!! hostname ASA-MSOFPED domain-name...

I have an ASA5505 setup and configured. DHCP is setup to hand out IP addresses on the inside. I have a host on the inside that is receiving and IP address from the ASA. I can ping the ASA (VLAN 1) from the host on the inside, but I cannot ping the same host from the console of the ASA. The...

Please disregard. I did not have the default gateway on the switches in this scenario. Thanks. Natesin... I am Nate, for I have sinned.

From what I understand you do not use a frame relay map on a point-to-point connection, you just use frame-relay interface-dlci 17. This doesnt give you the option for broadcast like a multipoint connection. RIP used broad cast for it's updates and frame relay is NBMA. How do I get the...

I have set up a lab with point-to-point sub interfaces and can ping between the routers fine. Here is on of the sub interface configs: interface seriaol0/0/0.17 point-to-point ip address 192.168.255.2 255.255.255.252 frame-relay interface-dlci 17 With multipoint and setting up a map you can...

I was thinking DYNDNS, but I thought there may be another otpion. Thanks!! Natesin... I am Nate, for I have sinned.

I am not sure if this is possible, but if any one knows of a way to accomplish the following, please share. I want to initiate a connection from an ASA that has a static public address to an ASA that has a dynamic address. I am not sure how this would be possible, but if so, please explain...

Thanks, but "the remote end" figured out what they were doing wrong... Natesin... I am Nate, for I have sinned.

I am able to establish a IPSec tunnel from the inside to the outside, but when an attempt is made from the outside to the inside, the tunnel will not establish. Any thoughts on how to fix? TIA!! Natesin... I am Nate, for I have sinned.

Thanx Jeter!! Natesin... I am Nate, for I have sinned.

Hello, This is probably simple, but I am looking to see if I can figure out when the counters were last cleared on a 4500 series switch. There are inactive ports (for like 23 weeks), but my boss wants to know when the counters were cleared. Any help greatly appreciated!! TIA!! Natesin... I...

Thats what I though. Thanks Brian!! Natesin... I am Nate, for I have sinned.

I want to PAT an address from an internal range of IP's (192.168.100.0/24) to 1 ip of 192.168.99.1 due to conflicting addresses. Does the interesting traffic used to establish the VPN tunnel become the 192.168.100.0/24 or is the IP of 192.168.99.1 used? TIA!! Natesin... I am Nate, for I have...

Thanks for your input. We have Cisco Aironet access point all over the place. What I am really looking for is how they do at motels when you want to get on to the Internet, you agree to a disclaimer on a web page then it lets you surf the Internet. Natesin... I am Nate, for I have sinned.