Recent content by NAMEIF

yes. we have enabled as a user local definition. The funny thing is last night working from home, I was able to see all logs for this fw, At work I am unable to see the logs. The changes I have made today are I have added a new node for this fw with internal Management IP addresswhich is is...

I am having problems with my smartview tracker logging. From user local definition on smart Dashboard under gateway, I am not receiving any tracking logs. Can anybody please advise. From Putty making change to firewall logging using port 22 SSH, I am configuring my new firewall to log in Smart...

the command is fine, but is not effectively being applied, # ifconfig eth-s2p1c0 x.x.x.x netmask x.x.x.x then when i do # ifconfig -a it shows the old ip address of that interface, I need to change this Ip address for the above interface using CLI. I have tried rebooting FW still shows...

i have tried this, it is different procedure to what i have done in the past, i am wanting to know the procedure of doing it from directly CLI rather than going via lynx. Please help Thanks

lynx, please explain in more details. I am a beginner, and are the commands right that i mentioned earlier.

Hello I am attempting to change the IP address and gateway address from CLI. I have done this once before, I have forgotten what i am doing wrong here. #ifconfig eth-s2pc1co <new ipaddress> netmask <mask> Is there anything else i must do after this, nothing changes on my interface, in voyager...

Hi I am receiving the following error message in my email as part of my logs status for my Nokia Fw with Checkpoint. mail product: System Monitor; System Alert message: FW-TEST is disconnected; Object: X.X.X.X; Event: Exception; Parameter: Status connection; Condition: is not connected...

Since are slos changing the Ip addresses this clearly affects the licenses therefore I beleive we have to push the licences again. Once this is done we need to start the Certificate Authority again and reset the SIC????????????????? Any tips or procedures on this would be appreciated.

Thanks for the speedy response. It is also being implemented ona different network and I would ideally like to have a remote access to the Management Server as well. I will get more information and post again ...

My company is due to Split with our partners, We both shared a same Management Server. Since we are planning on Splitting we will keep the existing Management Server for Checkpoint NG AI. We have few gateways that belong to Partner company. What is the procedure for getting all this done, I...

Could you please provide more specific details as in what options appear and exactly at what stage will i be prompted for Standalone installation as I can not find this. Thanks

Does anybody has any documentations or procedures for configuring the Standalone Firewalls and NOT the enterprise. I assume this can be done from the CPCONFIG utility available as per prompt option to select the installation type. 1.Enforcement Module 2. Enerprise SmartCentre 2. Enterprise...

My delay in my response, been away from work! Actually I have found an alternative solution to this from the syngress book - Nokia Security Handbook - pg 137. The backup can be done via backup confguration available in Voyager, Make sure you select both Default backup and backup home...

I am doing the backup from the Voyager- backup and restore-scheduled backup, yet it is still not doing a scheduled backup automatically, Although it has an entry of scheduled backup commands. In the scheduled backup i am adding an entry to automate the execution of commands on Nokia IPSO.

I have a Nokia Firewall IP330, IPSo 3.7/3.8 I am trying to create an automated backup scheduler from the Voyager browser interfce. I have downloaded articles from Nokia support website and have applied the commands ls >/tmp/out 2>&1 - This is applied successfully, however it is having no...