Recent content by mykul71

I disabled IPv6 in the registry and that didn't resolve the issue. UAC is is turned off. I haven't uninstalled and reinstalled the Networker client on the server yet as per 605's instructions. I opened a ticket with EMC support and they can't figure out what the issue is. We can't telnet to the...

I do have the firewall disabled. I have IPv6 disabled on the NIC but I am not sure about the registry entry. I will have to check that. I will also double check UAC. Thanks!

I think what I am going to do is just upgrade to ESX 4.0 then to ESX 4.1 for now.

I don't have any hardware to build a new vcenter server. I only have the two R900s. I checked the HCL and the cpus that are in the R900s are compatible with with ESXi 5.1. All the BIOS and firmware are up to date on the servers. How would I check to see if the HBAs are compatible with the newer...

I was asked to take over managing the ESX servers at my place of work. We have two Dell R900's with 64gb of ram in each box. They are connected via fiber through a fiber channel swith to a EMC CX4-120. The ESX servers are running ESX 3.0.2. We also have a server that is running Vmware...

Rovin, That worked. Thanks for the help!

I am trying to restore a storeage group with Networker User for Exhange server. I change the browse time, select the storage group that I need to restore but when I try to view the volumes needed for the restore the box comes back empty. Is there something I am not selecting correctly or is...

I am running an Exchange 2003 cluster BE. I have recently installed two Exchange 2003 FE servers in a load balanced configuration. The BE servers were the primary for OWA and Active Sync. After I installed the new FE servers they became the primary for the OWA and Active Sync. I had OWA Admin...

Thats what I figured. I will take a look at the PDF that you provided. Thanks for your help!

I have been tasked with trying to restore a vmware virtual server instance to a physical server. Not the actual vmware server but a client on the serer. I cannot find any Legato documentation on this. Anyone know of any docs?

So I would just treat it like a firewall and open the service ports. Ok, I'll do that.

I have two servers that are located behind a Kemp Loadmaster. I can confgure the client on the Networker server (7.3.4) and I can successfully install the client on the servers. When I start the backup from the server the connections fails and when I start a backup from the client it states that...

I am currently testing and documenting the steps on how to recover our Windows Networker Server using EMC's document esg67348. I am using a single Networker server that backs up to a 24 slot library. Everything works fine until I get to the "nsrck -L7" step of the process. I have one tape on...

I am looking into an alternative to my current backup method. I was wondering if anyone had recommendations for backing up data over a wan connection to an offsite vendor. I have looked at Vault Usa and Iron Mountain. Are there any others that would be worth evaluating?

Ok, thanks for the information!