Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by muradj
-
Config. Opt. 81c PRI TIE to CISCO Catalyst 6000 Gateway (Call Manager)
I have used TIE trunks on EuroISDN for connection between Cisco and M1X11C. Everything works perfect. Also you can find all information regarding connection to the Nortel Meridian 1 on Cisco.com. Good luck.- muradj
- Post #24
- Forum: Nortel: CS1000 (Meridian) systems
-
Loop start configuration
What type of the CO card do you have? I meen NT number.- muradj
- Post #6
- Forum: Nortel: CS1000 (Meridian) systems
-
Loop start configuration
On my switch, which is equiped with CO trunk card NT5K18A I could use LGR signalling (Loop calling guarded release). But type of trunk signalling depends from software pakages too.- muradj
- Post #4
- Forum: Nortel: CS1000 (Meridian) systems
-
Similar problem with D-channel....
I have same strange situation with call routing on Meridian 1. This switch using as a tandem node with three following routes: 1. Route 10 – to Houston, E1 PRI2, QSIG TIE trunks. Slot 1. 2. Route 11 – to Remote office in Baku, E1 PRI2, QSIG TIE trunks. Slot 2. 3. Route 12 – to oil Platform...- muradj
- Thread
- Replies: 1
- Forum: Nortel: CS1000 (Meridian) systems
