Recent content by Mpe

You say you using EMG. Are you checking in TTY ore in "GUI". If "GUI" have you updated , at leasr, number series.

You have entrys in you name data base in PBX. So i would use NIINE :NAME="Smith John",NUM=2773; ore NIINE :NAME="Smith John",TYPNUM=ex;

This is the VW-Ware installaion point. It is necessary to connect a keyboard and a PC monitor/display via the appropriate connectors on the front of the ASU-E server unit. Setting up the Aastra 700 VMware ESXi host the first time after initial power up. Normaly at this stage you prees f2 and...

Is this not a A700 system. WHat you have is start to configure the VM ware on the Linux dísk. Mpe

Hi. I would use AC parameter in Domain that is set up in PBX. After that i would use DNT1 and DNT2 tables to steer where to connect mu calls. In DNT1 i would check if dialed number is AC+112 if yes trunk away dialed number. If not fix in DNT2 table that you trunk away AC from dialed number. Mpe

The problem is here ksdmi:dir=xxxx,key=12,ktype=fcn,fcn=ODN2; error NOT ACCEPTED MDN Key 12 is not a FCN key.

First you have to activate logging by IOELI:PRINT=RESULT; Then you can retrive command and log on log by: FIFCP:PATH=/SYSN/USR1/SES/IC/COMMAND19.DAT,FORMAT=ASCII; for command and FIFCP:PATH=/SYSN/USR1/SES/IC/logon09.DAT,FORMAT=ASCII; for "loggon log". Mpe

Hi, If you have an IP network take a looke at this product. http://www.iptc.se/Documents/DEX28_GE2P_Data_Sheet.pdf We use it and it woks great. Mpe

Hi. Type OPTSP; OPTSP; OPERATOR TRAFFIC STATUS DATA DIR BUSY/FREE ABSENT/PRESENT 37461 F A 37464 F P WAITING TIME FOR OLDEST CALL IN QUEUE: 0 S CORG WAITING CALLS OPERATORS PRESENT 1 0...

Hi. If you want to have 51 as an OACC you can't have any exstensions in these number ranges, i.e. 51XXX. Mpe

Well IPURI wont reboot the telephone in many cases, it will force the telephone to read the config file. Surf to the telephone, log on and go to network. Push apply all settings. Ore use putty, log on and type reboot. Mpe

Are you running on H323?? The you can't send DTMF tones, not supoprted. Mpe

What software are you using on the IPLU?? In R4C there is a problem with DTMF tones. MPe

Hi. WE have one installation with ISDN-NET signaling. We use ROU TYPE VARC VARI VARO FILTER 42 SL60 H'00000300 H'00010000 H'00310000 NO <ROCAP:ROU=42;ROUTE CATEGORY DATA ROU SEL TRM SERV NODG DIST DISL TRAF 42 011100000000001 4...

Have you checked what "Information System ID" you have in the setting of GICI/CSTA port configuration? Have you set up the inforamtion port in MD (ICFUP) with same ID?? Have you set up ISFUI and tied it against ICFUP??