Recent content by moh210383

Thanks! Will check with the carrier if he can provide disconnect. It's a remote place and the CO is quite old there Marc-Olivier Habel

Hi Customer is receiving bunch of phantom calls from people hanging up during the AA greeting. With no disconnect on his lines, call stay connected and get transfered to the operator at the end of the AA. They also receive a lot of blank messages. Is there a way to tell AA to hang up instead...

Hi Is there a way to record an active call on demand using the CallPilot 100. Like a fonction code 98something Thanks

Hi Can I put a call on hold with an analog extensionon Nortel products? Thanks Marco

I finally got the .lic file and uploaded it to the BCM50 and it work well. Thanks for your help!

Hi I need to add keycodes to a BCM50. I got the keycodes but I don't know where to go in the BCM element manager to add them. Maybe there is a way to add them via phone? Thanks

Hi I need to add keycodes to a BCM50. I got the keycodes but I don't know where to go in the BCM element manager to add them. Maybe there is a way to add them via phone? Thanks

Hi everyone Does the iP2033 conference phone can connect to any SIP provider or it's only a Nortel iP Set. WHat I mean is that I would like to interface that conference phone on my Toshiba CIX. Thanks

Got it Thanks guys

What does it look like? is it like a mac address?

Hi everyone I need to retrieve the serial number of a BCM50 with the phone because I don't have the password to do it via BCM element. Anybody knows how to do it? Your help is very appreciated

Hi you who will read this post My boss ask me to install a companion lab at our office. Companion are a complete mystery for me. I do know quite a lot about the Nortel product line but not those wireless solutions. I have the antenna, the handset, the MICS 4.1 and everywhere I look on the...

For your info you were all right and my programming was OK. I went onsite today and find out that the line 3 goes trough a Fax machine before the phone system and this fax machine don't transfer caller ID. Fail Thanks for your fast answers

Hi everyone I have a problem with the caller ID on a 3X8. Caller ID work very well on line 1 and 2 but not on line 3. I've check the programmation and everything look the same for all the lines and also look at the Call Services section for the sets and look fine too. The caller ID on line 3...

The lines appears on sets but they don't ring. The only extension that has ringing is the reception. It's very hard to explain