Recent content by mlas

Hi Does anyone have an answer to this. I am having the same issue on CS1K Rls7.5 to an IP Office Rls 7 Cheers

Hi I did a DCH trace and when I dialed from a test site 71235xxx I see the call come in and the IDC table has 71235 5 but its not applying the translation?

What type of end point is it, H323/SIP?

I sure did. Sorry thats what happens when your doing work on a PABX and writing a question at the same time.

Hi we have a CS1K Rls 5.5 that uses H323 virtual trunk.In the RLB I have associated a IDC table and added entries but it doesn't seem to use it. Can anyone confirm that you can use IDC on Virtual Trunks please. Cheers in advance M

Hello Does anyone have an example of how to configure an MCDN link from start to finish? Thanks in Advance

I have a problem where occasionally one of my pty ports is getting locked out - OVL 400 TTY 11 30. But when I issue the WHO command it only shows my connection on a physical TTY port. When you stat in 37 you see the pty port enable then after about 5 secs it disbales again, then enables and so...

Yes. The app builder does a transfer to a CC6 aquired CDN.

I have tried to front end CC6 with callpilot but callpilot seems to keep control of the call. It plays a menu and when I select option 1 which transfers to a CDN it will only work if I have an idle agent. It returns back to Callpilot if when it goes into CC6 I try and play an annoucement. Any...

Hi I am trying to create a 500 set on one of our sites using TM3.1. The set validates ok but when I click on Finish it comes up with the following message: ERROR: duplicate key violates unique constraint "telephonefield_pkey" Has anyone had this and how can it be resolved. Thanks for any...

Hello Is it possible to create a distribution list in outlook that has external fax numbers in so it can be used to send a single fax to multiple external numbers?

Can anyone tell me if this is possible and how I go about programming it? We want an analogue extension(ringing bell) to ring when anyone calls a particular digital extension. Is this possible and if so how can it be done. Thank you for any help I recieve.

Thanks for all your help guys, much appreciated.

Hi hope someone can help. We have a CS1000M (OPT61) running 4.5s/w. We need to connect a paging system to the pabx. Can a MIRAN card act as an interface for this? If not what other hardware woudl I require? Thanks for your responses. Regards M

Hi Does anyone know if it possible to backup and restore the voice segments used in Application builder, either individually or as a whole?