Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by mjs222

  1. mjs222

    FUJITSU 9600 - Trunk to Trunk Connection

    I found the problem, but I don't know how to close this post.
  2. mjs222

    Problems using the VACDN

    Ok, I got it to work. But I did some test calls this morning. Everything looks good but caller ID from the outside. I can get the 4 digits both way accross the PRI. But when I call from any outside number, my cell, from a transferred call or from the my office phone, dialing 9+XXX-XXX I get...
  3. mjs222

    FUJITSU 9600 - Trunk to Trunk Connection

    Need to do a trunk to trunk connection from a FIPN to PRI CISCO and from Super Trunk T1 to the same PRI CISCO.
  4. mjs222

    Problems using the VACDN

    That is 601 and it's in every COS 0-63
  5. mjs222

    Problems using the VACDN

    I am now trying to program in the access over the new PRI to CISCO. I have programed in the Trunk Groups Dch 202 and Bch 203, access code *30. All that look good, but then I go to use VACDN for X5730 or X8299 (to DSTNO 100 = *30) the display says DENIED or if I call over the FIPN it says Invalid...
  6. mjs222

    MML

    Yes, the MAT is set up for 7,E,1 and baud eate is 9600. It is also set to echo-off and capture-none
  7. mjs222

    MML

    Ok, I'll sheck it out
See more

Part and Inventory Search

Back
Top