Recent content by mitelbr

I never did that (using PNI to join cluster). How can I do that? There is no number conflict between sites.

There are two sites. Each site has two pbx in a local cluster. Customer wants to share the phonebook between clusters. Is that possible?

Hello. Customer asked me to share phone book between their two sites and each one has a cluster. How can I do that? I tried to share Telephone Directory between two elements from each site. I received an error message saying that the element is already on other cluster. Is there a way to...

Today the system is working with a voicemail mailbox receiving and forwarding messages to an e-mail. When people call the mailbox they need to listen an announce before leaving a message and I need to know if record-a-call is capable to do that like voicemail and if I can do that with only 2...

Thank you, sarond. Can I set call recording to do the same thing as the embedded vm? I need to set a mailbox number to receive calls and after the beep people leave messages and then those messages are sent to an e-mail. Can I do that with call recording with 2 vm licenses? Thanks for your help.

MXe III MCD 6.0 SP2 Do you know if there is a time or size limit for the messages received in a mailbox? I set an embedded voicemail system on a customer system and when we tested how much time a message reach we got a limit of 5min. Can I set the time limit of the mailbox messages? I...

jrgood0852, Thank you for your help.

As I suspected, It was the firewall. The comms between systems are "established" now.

Well, if you were right I would not have been able to set a cluster and I did (system 5.0). I appreciate your politeness. So the question remains: Do anyone else knows if there is a known issue with IP Networking between system versions 6.0 and 4.2? It could be a problem with customer firewal...

Hello, gentlemen. I am trying to set the communication between those different systems versions. I am receiving "out of service" status from system 6.0 SP3. I did the same between systems with versions 4.2 SP2 and 4.2 and it worked. Do you know if there is a known issue to put an IP network...

Ok. I don't have the access to the Singapore system because it is not part of our support. But I need to give them info about the cluster so they can set the ip trunk there. kwbmitel, So the infos I sent here about the possible configuration are correct? If they fill the Cluster Elements...

Hi, Dan. This is the first time I configured a cluster. I followed the manual. I don't know what is the best way to make the communication between a cluster and a 3300. Is there a best practice? I understand what you say. If we have only two elements in a cluster, there is no need to...

Hello, gentlemen. I made a cluster with two MXe III. The MCD is 5.0 SP2 PR2. The cluster is working fine. I need to do an IP trunk between this cluster and a 3300 ICP at Singapore. I think I need to programm in the Singapore Network Elements form both infos from the clustered MXe's and...

I didn't make it work with your infos, dan. It worked in the DMZ when we use the 3300 IP address in the ICP-side stream field and the public IP in the set-side stream field. Anyway we needed to put the MBG to work with redundant internet links through NAT but how to do it when we already...

I am going to visit the customer on 08/17. I will feedback you. Thanks.