Recent content by metrolog

Thanks

Thansk for your help, I have tried to find info on setting up a ccna lab but to no avail. Basically I wandered if this would work. 2501 (serial 0) thru DB60 cable to 2520 (serial 1) 2520 (port ?) thru rj45 cross-over to 2611 (port ?) 2611 straight rj45 to hub, then from hub to nic(PC) As I...

If you have the following: 2501 router 2520 router 2611 router & 3 com hub Can anyone advise on what cabling is required and how it should be interfaced ? (Sorry I'm new to all this, thanks)

Can anyone advise on the best way to configure the following: Lab1 2 X 1601-R 2 X 2501 1 X 1912-EN 2 Tranceivers, 2 DB60 cables. Lab2 1 X 2501 1 X 2520 1 X 2611 2 DB60 cables The equipment can be mixed and matched for sim CCNA certification purposes Thanks.

Sorry I meant in the last paragraph (Switch 1912 rear console to COM port of the PC) Thanks

Hi dogbert2, will this work ? when the two routers are connected via back 2 back seriel cable (seriel 1 db60 to seriel 0 db60) and, two tranceivers from both router AUI ports plugged into 10baset ports (say 1 and 3 of the 1912 switch) and the switch is connected from it's rear AUI port to...

Hi dogbert2, thanx for your info, like I said I'm really new to this, unfortunately I was wandering if you or anyone could advise on how to connect all this gear, I forgot to mention I have two tranceivers with rj45 leads, two b2b seriel leads no IOS, how do I connect all this up. Thanks.

Hi, I'm sorry for being ignorant, but I just wandered if anyone could help me with setting up a CCNA simulation home lab. I have 2 X 2501 routers, 1 3COM hub, 2 tranceivers, (and a switch 1912EN which I hope to use in the near future) My computer has a RJ45, lan, com port male I'm a bit new to...