Recent content by mertech

I have a CS1000E running Rlse 5.50 and DECT. The DECT cards are split in slots 0-0-3, 0-0-4 of the Media Gateway and 0-0-7 of the expansion. We are having trouble with the DCS sets registered to DMC in slot 0-0-7. We are getting one way transmission between DCS sets and are unable to register...

You cannot go from rlse 18 straight to Rlse 5, its a two step process. Only from R23 and above can you go straight to R5

The Operator can call the extn no problem, with the incoming call on-hold, but once the operator extends the call to the extn, then the extn cannot hear the incoming caller

I have a problem with a R25.15 Option 11C, and a 2250 console. The 2250 can answer incoming calls with no problem. The call is then transferred internally, but the extension to which the incoming call is transferred to cannot hear the incoming party. The 2250 has been swapped out and moved to...

the CPU's are CPPIV

I have a Campus redundant CS1000E running 4.5 via a Passport. When both CPU's are rebooted, they seem to come up cleanly, one CPU shows active, the other redundant. The HSP shows up and connected. BUT, when you do a SCPU, both CPU's come back active and unable to 'see' each other. It does not...

Has anyone configured this, from a CS1000S to a Realitis using QSIG?

If you have an i2004, then instead of PRT/TNB, try PRT/i2004. REQ PRT TYPE i2004 TN etc

Can anyone provide me the setup for a Quintum Tenor AX box and a CS1000 utilising H323...Pictures would be nice so I can anotate them with my crayons

What changes did you make to CCS_DATA

Usually, only need HFA in CLS

You don't need a SCPW for Electronic Lock, so no need to sysload your system, phew. If you get a tone and nothing is happening are you using SAR groups, as these override ELock.

DITI should be under the NET gate opener and the message you are getting on the D-Channel sometimes points to barring, check TGAR/TARG or NCOS settings, if you have SIGO set to STD on your RDB then you are not sending your NCOS and the call will pick up the NCOS of the Incoming trunk by default

Just a thought are the DCH's and TTY port on the same MSDL card.

Firstly, there is no battery on the CPU board. If you mean the small silver object that looks like a battery, thats your Security Dongle which is used to match the system with the keycode. If you remove this the switch will not validate the security and will not work. It sounds like you have an...