Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by MediTech
-
tty1a not dialing out, no modem Response
Thank you again, really appreciate all of the input. Finally got it WORKING!!! What I did was so simple. I simple made sure both tty1a & tty1A disabled, shutdown, removed the card. Booted up, again made sure that they stayed disabled eventhough no card. Shutdown, put card in & booted up. Then...- MediTech
- Post #6
- Forum: General UNIX discussion
-
tty1a not dialing out, no modem Response
Thank you, but when we installed the 3rd board & made sure the Jumpers were correct I got the following: Warning: Serial garbage loose cable on dev 0 port shutdown then init: command is responding to rapidly check for possible errors id Se1a "/etc/getty tty1a m" checked the settings...- MediTech
- Post #4
- Forum: General UNIX discussion
-
tty1a not dialing out, no modem Response
I also just learned that on the modem the TR light is not on, so now I am replacing the board again - still no tr light... help... :-)- MediTech
- Post #2
- Forum: General UNIX discussion
-
tty1a not dialing out, no modem Response
tty1a is not responding to our attempts to dial out. port disabled, modem was checked & is okay, there was a lock on tty1a, which I removed. Our vendor thought that our serial board was bad, so we replaced with a WinBond 85757F, still same problem. Currently, we are putting to old board back...- MediTech
- Thread
- Replies: 5
- Forum: General UNIX discussion
