Recent content by MDfreak

hello the only thing you have to do to rewrite EIC is to send the NIU2 back to /// cheers

hello the upgrade cost is depending on what do you want to add to the system features i.e. IP extensions , truncks , etc included in the license cheers

hello does niux is only for NIU/NIU2 or can be apply for IPU? what's diffrernces? cheers

it's phased out in ///, but you still to look for other sites in ur area to have a spare one.

Hello it's not i guess, may be you just pull it out and in again. i.e. restarted.

which BC release do you have and do you have REU's still in MAG,s

Hello you can install RG%DC on each MAG of your system unless you have REU in that MAG. for doing that you need to do the following: 1- change the switches to this position the 1st one to right and the last one to right, don't change the others. 2- power off your MD110 and replace each PU5DC...

take alot of care if you write EIC on NIU2 you won't can over write it again. as well as, writing EIC is done once for NIU2.

Hello All how could i establish a DISA connection trough external Analog Trunk, i intiated the DISA function by using: NANSI:NUMTYP=DI,NUMSE=xxx; then the AUCOI:AUTH=xxxx,CILCOD=xxxx,CAT=XX; where xx is the catogry for disa number, all is ok even when i call from outside the system to dial...

did you install any new device recently?

connect the same cable to ur PC and try to connect via NetMeeting using gatekeeper IP address in ur MD110 and a telephone number for the IP extension. it should connect if you have no problems,

check the paramter PARNUM=253,in AS paramters

thanks LME but i solve this problem through getting the INL from another system, about ur way using niux, where could you specify the directory. is it the command : mkfs ?

i did contact them, i dout in a bug cuz i've done that before many times and it works, i still waiting for response from E///, thanks trond456

Hi all I just upgraded a lisence file on BC12 system, the customer was had a basic lisence , the DISA feature was added to the lisence and updated, but, the problem is : you can't intiate a DISA number reason: no lisence avilable when printing LIDAP: it gets the lisence ok with DISA enabled...