Recent content by md110user

Hi Daddy What is CSTMP command I did not find it in ALEX BC11 SP8 And Is this patch working for BC12, Standard Market. Regards MD110USER

It is fine with me. Make sure the NIU board is O.K. and FW also is O.K. Regards

Hi How can I make that? broadcasting in MD110! could you please tell me how to make it. Regards

Dear Sir How can I end this link or change the position GSMULT=0-7 I want to change it to Position 0-25 because the PINS on the Bakplane of GroupSwitch Magazine is broken on that posiotion. When I want to blook then end I receive a message: No ANSWER FROM GAR How can I change the position...

Hi VMPOP If there is a Patch, we are all looking for it. Could you please tell us about that patch and which parameter to change it in Extension to make time adjustment for cutting of the call after some time (let's say 5,10,15,...Minutes) Thanks in advance Regards MD110User

Hi How could I loggin to Win2K server whithout need for "CTR +Alt+Del" and typing the Username and Password? I need to loggin automatically as an Administrator, like what I can do in Win2Proff. so if the server which is in my case "stand alon" restatred it can be returne back to the desktop...

So What is the defult password and username? Regards

Daddy A friend of mine face the following: I have an analogue card ELU34 on BC13, I made ICAT=800000 But the caller ID does not work Is the signalling DTMF or FSK ? My analogue set support DTMF only Regards

Hi Guys I have a site where DID/DOD is used, When I make a call from any extension the MD110 send the extension number and a prefix xxxx ( four digit) e.g.: the route is 88 so RONDI:ROU=88,EXNOpu=0-xxxx; So the B-answer (which is a public subscriber) will receive "xxxx1234 where (1234 is...

Hi All I have MD110 BC12 Sp6, I need a Voice mail system so : OneBox is the choice of the customer but I have questions: 1-What is the type of the integration between OneBox and MD110 and if there is a sample programming from the MD110 side ( I mean is it a serial V.24 connection or a TCP/Ip...

hi LifeSentence Regarding of NIU/1 to erase EIC on FWR17a firmware, what is the command to do it. or how can I log-in to the privilage mode, I need different way than used with FW like "R6A" Thanks in advance

HI Pabxer Could you please type the whole commands, because I try this method through the modem but it does not work with me? May be it does not work though modem connection "speed=1200" or may be I typed the wronge parameter! thanks in advance. Regards

to singhbrindisi You are right I am looking for the corrections that had been made on the new FW. Regards

to affy1977 Welcome back

Sorry for typing mistake. Hi guies, 1-What is the improvement on FW:R18A for NIU/1? 2-What is the improvement on FW:R7A for NIU/2? Thanks