Recent content by mbd0722

Thank you andy88 for your help. This was very much appreciated by all of us.

PROBLEM FIXED - From the Technicians Interface I entered the command "password Manager". At the enter "Old Password" prompt I just hit the Enter key. At the enter "New Password", I entered the password that I wanted. Again I was prompted to enter "New Password", which I re-entered. This is for...

I was later able was to boot into the Diagnostics Mode's "diag_1>" prompt by entering "CTRL+C+ENTER" during BOOT and I removed the password with the d/l/n:5 410000 0 command. I then booted the router with the "config" file which contains the password that I want to use. New Problem: I am able to...

The functioning password that I want to remove is not displayed in the MIB list of get wfSnmpCommEntry.3.*. This is the problem. This password is also not displayed in the TI via "show snmp managers" and is not displayed using Site Manager via "Tools > Configuration Manager > Dynamic > Protocols...

One known and functioning password is missing from SNMP MIB. I know the other two passwords, "password_A" and "password_B" within the SNMP MIB for accessing the router through Site Manager. These passwords are displayed within Site Manager 15.50, the Technicians Interface, and Site Manager's...

Is there a way to backup, upload and download the configuration and parameters of a Toshiba P3 Variable Frequency Drive to a computer? Thank You

I have just started learning the GE Fanuc VersaPro 2.0 PLC programming software from the PDF files. What is the purpose of the files with extensions .PDT and .INX? What tasks do they perform or what type of information do they store? I have found information on the .BLK, .VVT, .RVT, .FLD...

I would like to know how to repair and service PC Notebooks/Laptops. Do you know of a quality Notebook Repair Service and Support Course that I could attend or purchase? I am familliar with Desktop Service and Support. Thank You

We were looking for a paperless chart recording system for a high speed application but all of the ones which we reviewed were attractive but out of our budget. We have been quoted an Allen-Bradley solution which seems attractive and reasonable. Also we are in the process of setting up one of...

Thank you for your response Kalisto and rayatucdavis. I will use the N registers. I would like to pass messages, alarms, numerical data, and commands between an Allen-Bradley PanelView operator interface and a SLC5/03 controller. I have always worked at the bit level and not the word or file...

When would you use a bit address as B3:62/10, O:0.3/5, or I:4.1/2 instead of using the whole word such as B3:62, O:0.3, or I:4.1? Which is the correct method used for addressing actual outputs such as O:0.3 or O:0.3/5 "Turnstyle Rotate CW"? I am using RSLogix 500 for a SLC 5/03 and...