Recent content by mayubi

Got the SIP client to SIP client calls and Audio working both when behind a private LAN and over internet. However, when calling an Analog phone ( internal or external), using the SIP client ( connected over 3G or private LAN) can only ring, but when answered no audio. Is there additional...

Was observing the monitor for some time after the call established and then put one of the SIP client on Hold and saw these lines in RED 192.168.0.14 : SIP client in the private LAN 192.168.0.133 : DSL Router IP 78.100.190.131 : Nokia SIP client on Internet. ===========================...

Yes, one voice compression channel is used when I make a call . If we get this working, planning to increase the channels. We have the 3rd party endpoint license .

Also this : 61215307mS PRN: Monitor Status IP 500 5.0(8) 61215307mS PRN: LAW=A PRI=0, BRI=0, ALOG=4, ADSL=0 VCOMP=4, MDM=0, WAN=0, MODU=0 LANM=0 CkSRC=0 VMAIL=0(VER=0 TYP=0) CALLS=1(TOT=109) 61223847mS SIP Rx: UDP 192.168.0.14:49664 -> 192.168.0.133:5060

After the session/call gets established I see these messages : 59831176mS RES: Mon 13/6/2011 14:47:49 FreeMem=74386700(1) CMMsg=5 (6) Buff=200 968 1000 7454 5 Links=3707 59831176mS RES2: IP 500 5.0(8) Tasks=31 RTEngine=0 CMRTEngine=0 Timer=43 Poll=0 Ready=0 CMReady=0 CMQueue=0 VPNNQueue=0...

Did that already, no luck..

I dont have physical access to this IP office , however when I checked the System config/IP office Manager, under the control units I see device number 3 as : VCM32/ATM4 Attached the screen shot of the VCM config. The Ip address of this card is all zeros.

Tried again ,and this time the connection type is : Direct Media and the codec is : G.711 Mu, still no audio, checking the routing. However, the client on the local network as well have the same problem. My customer says that when this Demo was given, the vendor got a card which he...

I just installed X-lite SIP client( Extn 209) on the same PC where I had 3CX SIP client (Extn 210). I can make calls between these extension, while doing so noticed that conenction type is shown as VCM and the Codec as G.711 A for one and for the other client it shows G.711 Mu, can that be a...

Thank you Peter. I am bit new to IP office, so I should be checking the routing on the netgear router or the LAN-1 settings on the IP office. I am using only LAN-1 of the IP office and mentioned that IP in my 3CX SIP client. Regards, Ayubi

I am using 3CX SIP client , got them registered with IP office and can make a call to a landline, Mobile phone, another 3CX SIP client, Nokia SIP client... The phone rings, but once I answer the call, I dont hear any voice, and this happens irrespective of me calling a landline/fixed, mobile...