Recent content by matambanadzo

There is a key that you can define on the set, I think that it is called a 'ring change' key. With this key you can toggle any keys on that set for scn/scr. See how it works...

Hi, Your system appears to have a fault in the O.S. No options, re-install required, hope you have a backup.

Hi, Using the observe feature for any type of set, if configured correctly will observe any call from that set. Incomming to ACD-DN, incoming to PDN, outgoing from PDN etc. Provided you activate the observe feature you will observe all calls both in and out from that agent. Regards

Hi, You CCR/Link module does not necessarily have an IP address. It is possible that the service operates admin via RS232 and host link via X.25. However if you have an IP system, outside working hours if you perform a stop NSE and then a start NSE you will be able to define the IP address. Cheers

Hi, Do you have M390X handsets on your sytem, it could be that there are problems when the telset screens are updating, there is no need to concern, if you are worried your telco can suppress the message, otherwise just remove mtc messages from your port. Cheers

Hi Colin, To move the Meridian Mail to a different system requires input from your telco. Each system has a unique ID and a keycode is generated for the mail to work with a PABX of a certain ID, should you move the mail to another site with a different ID the mail AML link will not establish...

Hi, The best way to do this is to program a MCK key on any digital set. With this key you can cancel the message light on the set. However as the light is on this set may be the MWI dn for another mailbox, perhaps perform a find in the mail with this handset's dn in the MWI field. Cheers

Hi, Caller ID is not supported on 500 type sets. Cheers

Hi, The best solution would be to use traffic reports from ld 2. If you read that section of the NTP's you will find that you can set hourly reports to be generated for either network loops or, what would be better, route's. The only catch is that the PABX generates the report and outputs it to...

Hi All you need to do is create a Group Hunt List (GHT) in ld 18. It is programmed much like a speedcall list, simply assign the analogue dn's to entries in the list, once completed it would look similar to this when printed in ld 20. 00 5500 01 5501 02 5502 .. .. 15 5516 Once the list is...

To assign no function to a key on a telset, enter the key number and assign NUL to the key. When the set is printed there will be no function beside the key. Cheers

MPO is Multi Party Operation, it is configured in the CDB and once configured can be enabled at a set level.

The best way to do this is to use the toggle or disconnect optio in the MPO section of the PABX, enable MPO feature for the handset in question. Cheers

The ACD configuration indicates that the ACD-DN is unter the control of an auxilary processor. The auxilary processor, for example Meridian Link, has the ability to control the handset, in this case keys 0 and 6. Therfore it is most likely that the host computer program is telling the aux...

The best way to perform this is to use the PUDN flexible feature code. By assigning a RNP key as described above, all the sets need to be in the same RNP Group. All the operator needs to do is lift the handset, dial the PUDN code followed by the DN of the set that is ringing. The PUDN code can...