Recent content by marle

I have installed the system with build in scsi card and conected DAT. Now I have a /dev/rmt directory with 0,0b,... links. But the targets of this links are not existing? Whats the problem? cfgadm find again only the usb devices. Also no disks,is this normal? @marrow I dont understand what the...

hi marrow, the command reboot -- -r is working. But i have after the reboot also no hardware devices.Is on solaris a command like ioscan where i can see the build in hardware ?My /dev/rmt is a empty directory. marle

Hi, thanks for your help. I work with CDE and if I open a console and type in boot -r the system can not find the command, which boot can also not find the boot command in any paths. Regards marle

Hi, I am a newbie on solaris. But i have to do some tests. Therefore my questions: I installed solaris10 on a celsius pc. I build in a scsi pci card. I connected a dat drive. Now I find no hardware device for this dat.With the command cfgadm i can only see the usb devices. So it is necessary...

Hi greenpau, the ioscan show me 2 lancards. All are configured in /etc/rc.config.d/netconf But thanks for your help

Hi, I have problems with my lancard. After first reboot (hostname and IP-address were set) everthing is ok. After /etc/shutdown -r -y 0 the lancard fails. In the /etc/rc.log I have this message: ERROR lan0 interface: ifconfig: no such interface ERROR lan1 interface: ifconfig: no such interface...

On hpux 10.20 you have the chance to set the option secure on. Now you can´t boot in the ISL prompt! Solution: Disconnect the hard disk and possibly your DAT from the scsi bus (of course switch off your machine before). Now the machine stops automatically in the boot admin shell and you can...

On hpux 10.20 you have the chance to set the secure on. Now you can´t boot in the ISL prompt! Solution: Disconnect the hard disk and possibly your DAT from the scsi bus (of course switch off your machine before). Now the machine stops automatically in the boot admin shell and you can boot in...