Recent content by MarkSL

This is resolved. I cleaned the tape drive to fix it. Thanks all! Mark

Great, and how do I clear the alarm again? Thanks in advance, Mark

I have the following alarm in AUDIX: Resource Location Alm Level Fault Code Ack? Date-Time ---------- -------- --------- ---------- ---- --------- TAPE 01A1501 WRN 6 N 05/19/03 What does this mean, and how do I clear it? Thanks, Mark

How do I add a disclaimer to the bottom of every e-mail from Exchange 5.5? I recieve external e-mails all the time that have a disclaimer at the bottom of them, saying something similar to: "This e-mail and the files transmitted with it are the property of XYZ Company and/or its...

Thanks! I was 90% sure that the "15" meant the number of callers, but couldn't remember what the "m" was, and didn't want to change it until then. Thanks again! Mark

On the Definity G3si system, if you are programming a Vector, what does "pri m = 15" mean? It's used in the line "goto step 19 if call-queed in split 16 [COLOR=green]pri m = 15[COLOR=red]".

It's doing it again. I had to reboot to get the ports to show back up this morning. At first I tried shutting down the Spooler Service, then restarting it again. It seemed to fix the problem, until I tried to configure a port, then it started not responding within the port config wizard, so I...

WAY TO GO!!! That fixed it! The files were SPOOLSS.EXE and SPOOLSS.DLL. I'm thinking that the Service Pack didn't shutdown the Spooler Service when applying the Service Pack, and therefore it didn't successfully replace the spooler files during the upgrade process. Nevertheless, I manually...

How do I re-install the spooler itself? Never done that before... (Remember it's WINNT, not 2000) Mark

I am unable to add, delete, or configure any printer ports at all in it's current state. Mark

Unfortunately, that did NOT fix the problem. I am still unable to view the ports. Mark

Thanks! I'll look into this. You are right I have Service Pack 5 on it and didn't realize it! I thought that I had upgraded all of them to SP 6a. I'll have to install the newer Service Pack on it now. Thanks again!!! Mark

Maybe make sure that the printserver is using the right gateway? Not sure... check the routing tables on both the printserver and the clients... I know this probably isn't very helpful. Can you ping the printserver and the network printers from the user's workstation? Mark

Sorry, I left out some info. The OS is Windows NT 4.0 Server, the printers are a variety of HP printers, from 4 Plus to 4200 units. Thanks, Mark

I'm trying to add a new printer port using the type 'Hewlett-Packard Network Peripheral Port'. It won't let me, shows no MAC addresses under the 'Card Address' section. I can't see any printer ports for the printers already installed either. Where they normally are listed is completely empty...