Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations bkrike on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by maqsoodjee

  1. maqsoodjee

    Allow PPTP traffic inbound through a NetScreen in NAT mode

    Here is the Output " get vip " Virtual IP Interface Port Service Server/Port (myliveip) untrust 2048 CustomPPTP 10.5.5.5/2048(OK) " get pol " i am posint the policy related to PPTP Untrust Global Any VIP::1 CustomPPTP Permit enabled ---X- One More...
  2. maqsoodjee

    Allow PPTP traffic inbound through a NetScreen in NAT mode

    Hi I have Netscreen 5gt.I want to allow pptp traffic inbound through my router in NAT mode, for that purpose i have followed the juniper kb . http://kb.juniper.net/KB5471 But when i try to run this " set interface untrust vip 2048 CustomPPTP 10.1.1.10 " it gave me an error on '2048' " unknown...
  3. maqsoodjee

    Configure NetScreen Between LAN and Internet Router

    Hi packet. THank you very much for you time & interest . I have solved the problem. Problem is actulay i don't have any dhcp or dns server in my network & i use ether DSL / Netscreen dhcp/dns serverces so some how i don't know where but Netscreen show ip confliction due to which it stops...
  4. maqsoodjee

    PPTP Problem With NetScreen 5GT

    Hi , i have setup a Netscreen 5GT router in my network. DSL Router ----Netscreen ---- My Network. currently every this is working fine. but i face a problem using pptp. all of my users use pptp to connect our remote server. i don't know why but most of my user's are unable to pptp to the...
  5. maqsoodjee

    Configure NetScreen Between LAN and Internet Router

    Packet i just try to explain in a simple .I have 1 DSL Router ( Alcatel) 1 Netscreen 5GT 2 working Live IP's from the same ISP i am using DSL to connect with ISP through PPOE with NO DHCP , NO NAT. I assign 1 of my live ip(202.49.99.181) to etho (LAN) & connected that LAN port to Untrust...
  6. maqsoodjee

    Configure NetScreen Between LAN and Internet Router

    Hi Packet Thankx for you the time you have looked into my problem. Well i can't really understand about untrust as a DHCP client. Do you need me to send any config file to you. I have 2 Live IP's . so 1 is configured on DSL eth & 2nd is configured on NetScreen untrust port. DSL eth port is...
  7. maqsoodjee

    Configure NetScreen Between LAN and Internet Router

    Packet7 I Just recently bought NetScreen 5GT & plug the device in our network ... like DSL ---- Netscreen ------ Network. My question is what can i do. as i don't have any DNS as well as WINS in my network . If i gave netscreen ip in the dns internet won't work & if i have gave ISP's DNS...
  8. maqsoodjee

    Browsing Problem

    Hi I have setup my sonicwall to use proxy server ( squid ) for net. problem is that when i use Squid direct it browse perfectly . but through SonicWall i am getting some errors while browsing Can any body Please Help me out of this.??? The following error was encountered: Invalid URL Some...
  9. maqsoodjee

    Communication between two vlans

    Thanks for the reply . but i think i told you i am not using any router . i have just installed cisco switch in my small office & implement 3 Vlans 1 for my admin & 1 for my general user & 1 for accessable to every one like My server was on that Vlan.through that admin & general users has access...
  10. maqsoodjee

    ping batch help

    check the dir from where you have run this command. if you can't specify the path bydefault it will save on the current location from where you run the command. Otherwise you specily the location.
  11. maqsoodjee

    2 Nics, one for LAN, one for WAN

    Both nic can't communicate eachother as you surely setup private IP's for lan & surely you have a live IP for you'r WAN Connection. SO the mb is not used on the lan untill or unless you have configured NAT .
  12. maqsoodjee

    Setting up a network

    Check your machines that what ip address are thy getting or the static ip if you haven't assign yet. Now when you got the every or atleast 3 computers ip try to pinging with each other. try this on atleast 3 computers so that make sure that no body is pinging eachother. If they all are getting...
  13. maqsoodjee

    Communication between two vlans

    hi i am new to networks.i have cisco cat 2900 switch. i have created two vlans on my switch and add 4 ports to each vlan.now i understand they both don't communicate with each other due to vlans. but i want to set communication between both these vlans. can any one help me out.HOW is it done...
  14. maqsoodjee

    Two interfaces for Outbound & Inbound

    hi, i have question about how can i manage my trafic to go for uplink on 1 interface & for downloading it will go to 2 interface. I have a downlink from a satalite & 2nd one i have got downlink & uplink from ISP . Now i want to setup my system so that my uplink requests goes from my ISP...
  15. maqsoodjee

    Public IP Not responding.

    Hi, I am not using any kind of firewall & Router . just simply connected to the ISP through ISDN Line. The thing is i am using other services like internet browsing , MSN , ICQ etc . but my IP not pinging from the outer side. i have configured a simple website on this IP so some of my clients...

Part and Inventory Search

Back
Top